Goldstrike Strike Windshield Trim Installation for Honda Gold Wings
Vložit
- čas přidán 22. 07. 2024
- In this video we show you how to install our Goldstrike Strike Windshield Trim!
Get yours today: goldstrike3d.com/products/str...
Plug-n-Play Harness: goldstrike3d.com/products/cop...
Lighting Distribution Block: goldstrike3d.com/products/dis...
00:00 - Start
00:12 - Clean the surfaces
00:27 - Prefit the lights
02:13 - Testing the lights
02:45 - Taking off the mirrors
05:38 - Loosen the inner and outer panels
07:25 - Using a large cable tie to run the wires
10:18 - Routing the wire at bottom and back around engine
12:17 - Adhering the lights down
14:13 - Reinstall panel pins and screws - Auta a dopravní prostředky
I like the look, but I'm worried they would reflect onto the windscreen at night.
The Strike Windshield lighted trim is a forward facing light that does not impair you vision.
Just ordered mine... can you tell which colored wire does what? Turn, Run, Ground, etc. as I won't be installing as plug and play ... Thanks! These are cool !
Hi there, we do recommend using the plug and play harness, if you cut/splice wires that will void the warranty. For additional information on wiring please contact our tech support at techsupport@ciro3d.com or call 715-808-0027. Thank you!
My main concern is, when one or 2 stop functioning correctly, which can happen to any LED, these 3M tapes are very strong. Even with a heat gun, it will be a task to pull them off. This Honda paint can be so easily scratched and if you do scratch that area, very easy to notice it due to the location. I do like the kit and they are bright.
Hi there, be careful in removal and know that we offer a lifetime LED warranty, so a replacement would be provided, in the unlikely chance there is a problem.
There are techniques to remove VHB installed parts without a problem, simply contact our tech support for more information on that at techsupport@ciro3d.com
@@ciro3d_goldstrike3d Thank you for the reply. Good to know. After all, the paint job on the GW is not a superb job.
An appropriately applied use of a blow dryer and then finessing the use of nylon fishing line will take these and any other 3m backed product off completely. I have for years de-badged my Cadillacs, BMW’s & Corvettes like this. An often used technique of Detailers with no issue. Patience will serve you well.
@@roadglide OK. How do you remove the left over gluey black rubbery left over on the panel? What chemical will not eat the gentle, sensitive paint Honda uses?
@@alp3781
Warm soap & water. Gently heating area keeps adhesives pliable. Working small sections will enable you to roll those spots off. The process of de-badging patience is king. Hope this helps.
Driving a motorcycle, there must be CAREUD TPMS safer.