Easy Installation Kuebler Ants Shaft Copying Systems Elevator Landing Systems Kuebler - Kübler Group

Sdílet
Vložit
  • čas přidán 10. 02. 2021
  • Installation - Band
    1. Fasten a rail fastener (attachment
    device) on the lift rails. Tighten torque
    must be maintained.
    2. Connect the attaching device and band
    by means of carabiners.
    Notice: Ensure the correct lateral
    alignment of the holes. A mark is
    provided on the encoder for orientation
    purposes.
    3. Connect the Band, tension spring and
    securing band with carabiners. A
    distance of 75-105 mm (deflection 45-75
    mm + 30 mm carabiner) from the lower
    end of the tension spring must be be
    ensured.
    4. Hooking the carabiner into the
    attachment device.
    Notice: To ensure vertical mounting, the
    carabiner should be hooked into the
    same opening as above.
    Fastening bracket and Encoder assembly. In order to carry
    out later adjustments, do not tighten the screw firmly
    Ensure the correct position, which depends on the already
    mounted measuring tape!
    Guide the measuring tape through the side opening on the
    reading device. Check to ensure that the holes are correctly
    aligned with the mark on the reading device.
    Slide in the second sliding jaw.
    Insert the aluminium strip from above into the insertion
    slide-in until it reaches the mechanical stop.
    Place the fastening bracket on the roof of the lift cabin and
    make any necessary adjustments.
    Screw the fastening bracket in place and tighten the
    connecting screw
    www.kuebler.com/us/industries...
    Kuebler Inc. in Charlotte, North Carolina
    Address: 10430 Harris Oaks Blvd j, Charlotte, NC 28269
    Phone: (704) 705-4710
  • Věda a technologie

Komentáře • 4

  • @zuracxadadze4793
    @zuracxadadze4793 Před 2 lety +2

    Where are the gloves and helmets for safety why

  • @iran.elevatorhydroalic

    Helo what is this ?

  • @MrDidiHH
    @MrDidiHH Před rokem

    Leider ist die beiliegende Beschreibung viel zu klein geschrieben.
    Es dauert ewig um herauszulesen wie groß die Federspannung sein muss.
    Das System kann nicht an Schienen moniert werden welche an Bügeln befestigt sind. (GG Seite).
    Ich bevorzuge daher das System eines anderen Herstellers welches es zulässt dass das Codeband zum Lesekopf gezogen wird.

  • @rambir1512
    @rambir1512 Před 2 lety

    Sepati