DIESEL LISTEROIDE 6/1 ENGINE

Sdílet
Vložit
  • čas přidán 21. 08. 2024
  • My Clone Lister (made in India) 6/1 startup and running
    Single Cylinder
    6hp
    650 rpm
    700 lbs
    It has low hours and runs like a clock, it was supposed to be my home generator but I never had a chance to set it up properly
    amzn.to/3BH7huQ
    (monetized links...thank you for your support)

Komentáře • 39

  • @robertbodell7221
    @robertbodell7221 Před 6 měsíci +1

    I had a 800 rpm 6/1 in Texas I ran on waste motor oil at 300 rpm and got 8 hrs to a gallon. After 3 years and 4800 hrs zero carbon on the piston. I ran it through a centrifuge to 5 micron, heated it to remove water and brought acidity down to neutral. Will keep in storage indefinately.

    • @dabprod
      @dabprod Před 4 měsíci

      Hi Robert, hope you are well. I remember your videos.

  • @boathemian7694
    @boathemian7694 Před 6 měsíci

    I love these things. Especially the water tap directly over the generator head lol.

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před 6 měsíci +1

      The tap is there to service the coolant every now and then, but you are right, it’s poorly located

    • @boathemian7694
      @boathemian7694 Před 6 měsíci +1

      @@JoeBakerOutsideTheBox no man it’s awesome, I’m just messin with ya lol. I’m not an inspector, just jealous I don’t have one of those!

  • @nymack66
    @nymack66 Před 8 měsíci +1

    The source of electrical power for our home from 1960 to 2023 in Guyana SA.

  • @badenpascoe3976
    @badenpascoe3976 Před 4 lety +7

    Yep, all Listers run clean. Remarkable little engines.

    • @dabprod
      @dabprod Před 4 měsíci

      Problem is the EPA doesn't think so.

  • @andreaspolaor5876
    @andreaspolaor5876 Před rokem

    Bellissimo video
    Mi piace tantissimo il motore Lister
    Nel mio stato Italia non esistono questi motori
    Ho fatto dei video di quello che faccio io con quello che trovo qui .
    Complimenti bel lavoro

  • @iwantosavemoney
    @iwantosavemoney Před 3 lety +2

    So cool

  • @MoreTubContentOnMyChannel

    "alriiiight"

  • @thomasjehnkins1986
    @thomasjehnkins1986 Před 4 lety +2

    Gee I wonder if you emission test it at temp what would the levels be...certainly cleaner than some diesels I have seen people rollin coal with...

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před 4 lety +1

      Well, its a backup for a solar setup, so I guess the the nasty emissions are offset by the clean energy of the sun

    • @jackmcgramm2259
      @jackmcgramm2259 Před 3 lety +2

      run it off wvo or biodiesel. then its carbon neutral.

  • @wi11y1960
    @wi11y1960 Před 3 lety +3

    Love the vid. Planning on getting an 8hp for $313 from India.
    Your engine bolts seem loose.

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před 3 lety +3

      Thats a good deal, parts are easily available...my engine wasn't secured properly yet on that video, lots of shaking but all the bolts were tight

    • @hamadilawson4396
      @hamadilawson4396 Před 3 lety +1

      How would I go about purchasing from India?

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před 3 lety +4

      @@hamadilawson4396 they are illegal in the state (epa regulations) but you can import an air pump wich is exactly the same as the 6/1 without the fuel system ( which you can easily find on line).

  • @NickOvchinnikov
    @NickOvchinnikov Před 3 lety +3

    Could you run bunker oil? Maybe use the coolant to heat transfer to the thick bunker oil to thin it out?

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před 3 lety +4

      For sure you can, the trick is to have a dual tank that you can switch back and forth. One of the tank with regular diesel to start and warm up the engine then switch to bunker oil to operate the machine and just before shutting down switch back again to diesel to diesel to clean up the fuel system

    • @rileykirk11
      @rileykirk11 Před 2 lety +2

      would bunker oil, properly heated to good viscosity, change performance or leave buildups? should maintenance change? affect on power or g/kwh? no.6 bunker is 151-155k btu/volume and no 1 diesel is 132-137k btu/volume

  • @mainelyelectric
    @mainelyelectric Před 3 lety +2

    Did I see that you had oil in under the valve cover? And how often do you have to add it? Any special oil?

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před 3 lety +3

      Hi, I used straight w30 motor oil and depending of the usage, I just kept an eye on the level daily and top it up as needed

  • @goodmanboattransport3441

    What is the diameter of the crankshaft where the start handle fits?

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před rokem

      Hi
      Its 2 inches
      www.centralmainediesel.com/order/Hand_Crank_Handle.asp?page=Hand_Crank_Handle

  • @offgridinthepacificnorthwe3210

    Greetings, I am having a hard time getting a lister 6/1 clone here in the US. I heard that you can buy the air compressor model and change the head. I use a Yanmar diesel. It is very fuel efficient but I dream of something quiet like the 6/1 @750RPM.

    • @JoeBakerOutsideTheBox
      @JoeBakerOutsideTheBox  Před 4 lety +6

      Hi
      I know those guys ship in the great USA, www.justliveoffgrid.com/ and from what I understand the air compressor is exactly like the 6/1 without the fuel system. For the fuel system check out Central Maine Diesel (State of Maine) www.centralmainediesel.com/

    • @NoelBarlau
      @NoelBarlau Před 4 lety +2

      Here's who to contact to do that very thing. joanna@lovson.net

    • @offgridinthepacificnorthwe3210
      @offgridinthepacificnorthwe3210 Před 4 lety +3

      @@NoelBarlau thank you so much!

    • @NoelBarlau
      @NoelBarlau Před 4 lety +1

      @@offgridinthepacificnorthwe3210 You're welcome. Happy compressing!

    • @brianmcmenamin7269
      @brianmcmenamin7269 Před 4 lety +3

      If you buy a new Listeroid in a crate remember to go through it with a fine tooth comb before start up. The crankcase will have sand in the castings which will destroy your bearings etc..! Once cleaned they are a strong reliable engine!

  • @motupatlu9919
    @motupatlu9919 Před 3 lety +1

    HP?

  • @salumujuma
    @salumujuma Před 8 měsíci

    How much

  • @annasabhegade5135
    @annasabhegade5135 Před rokem

    Price list