John, I just wanted to say THANK YOU for your help. I ride 2010 cbr600rr and you and your cbr600rr maintenance series are two of the reasons why I don't want to change bike. By far the best instructor on CZcams. Thank you!
Looks like a near installation, but the Kawasaki connectors did not look to be sealed auto quality connectors like Weatherpack and similar. Given that, I would pack them full of dielectric grease and I would apply shrink tubing over the splice.
If wiring up multiple lights to run from one switch, do you have to run them through a relay if using this fuse box, or just write them in parallel using the same method as in this video?
Just bought a 2015 Mule Pro FXT. Great condition. Checking everything out. Found that the two 12 volt accessory sockets in the front panel do not work. I think I found the fuse, ACC F. Fuse not blown. Any ideas why it would not have power. Reading 0.07 Volts???
I installed a light bar on my Kawasaki Teryx4 LE a week ago. For some reason the unit would not start. Dead battery... I put the wire harness that came with it on the unit.. not sure what’s going on? Should I buy a wire harness from the factory? Or?
John, I just wanted to say THANK YOU for your help. I ride 2010 cbr600rr and you and your cbr600rr maintenance series are two of the reasons why I don't want to change bike. By far the best instructor on CZcams. Thank you!
Keep up the good work! Love your videos.
Try using a razor knife to cut the knockouts for your switches it's super fast and a whole lot cleaner and they cut like butter
Looks like a near installation, but the Kawasaki connectors did not look to be sealed auto quality connectors like Weatherpack and similar. Given that, I would pack them full of dielectric grease and I would apply shrink tubing over the splice.
If wiring up multiple lights to run from one switch, do you have to run them through a relay if using this fuse box, or just write them in parallel using the same method as in this video?
John if at all possible could you do an install like this but with one of the 2017 or newer Polaris sportsman 850 or 1000. Thanks
Would like to mount one on the top rear of the cab to serve dual purpose as rear bed cargo light and backup light. Any suggestions? Thank you.
Same basic process, just a lot more wire.
@@PartzillaParts thanks.
John is great. Question: hurt anything to put on 30" tires on my 2016 Mule 610 XC 4x4?
I don't recall ever seeing one with 30" tires. Not sure, I would verify the clearance in the front first.
Just bought a 2015 Mule Pro FXT. Great condition. Checking everything out. Found that the two 12 volt accessory sockets in the front panel do not work. I think I found the fuse, ACC F.
Fuse not blown. Any ideas why it would not have power. Reading 0.07 Volts???
Bad connection, corrosion?
the acc wires in front under the hood are for the horn and arent meant to be a constant 12v supply
What about a video on an sx?
I installed a light bar on my Kawasaki Teryx4 LE a week ago. For some reason the unit would not start. Dead battery... I put the wire harness that came with it on the unit.. not sure what’s going on? Should I buy a wire harness from the factory? Or?
Either you have a short and battery drain or blew a fuse?
You don't have to have that fuse box harness
What $
wanted to know how much for the kits, you have to create an acount, then add to cart, then check in check out...what a scam !!!!!!!!