[LG Washing machine] - Run a Tub Clean Program (tCl) after an OE error.
Vložit
- čas přidán 15. 06. 2021
- This video shows how and when to run a Tub Clean Program (tCl) after an OE error.
Also check service.academy.lge.com/#/trou... for tips and tricks.
Music: www.bensound.com - Věda a technologie
If your machine won't drain try blowing hard into the drain hose. Mine came free and saved me from having to take the machine apart to clean it, replace the pump or calling a guy out
That might also do the trick, but if the drain hose is really dirty the Tub Clean program really helps as well. For draining you may also think about doing a hot wash (95 degrees C) to clean the drain path.
The video is helpful but the problem persists. I ran the tub clean program and at the end of the cycle it brought back the error and the water is standing on the drum. What do you suggest. LG support ? We really need to get it going.
I have already opened it up, I checked the draining grey hose, checked the black wide receiver hose and both were clear and cleaned. I put it back together and ran the cycle again. Same results with the error and water standing inside the drum.
Thank you for the prompt response.
Dear Sergio, thank you for commenting on this and describing your problem. If Tub Clean does not solve your issue I suggest you contact you local LG helpdesk, as you may need a technician coming over. There could be several possible causes for an OR error and you may also want to check our support portal at service.academy.lge.com/#/Troubleshooting, select washing machine > OE error.
Hope this helps.
Hi,
Can we use soda in tub clean function after OE error?
Yes you can, but not too much (check the video) and do not add clothes. Note that there are other to check steps to resolve an OE error: service.academy.lge.com/#/troubleshooting > Washing Machine > OE.
Good luck!
Play/pause button is blinking while TCL error shows up at startup - after that, I can't switch the TCL program (for my model, it is a touch screen button on the front panel, with a *)
This is an advice, but you should be able to use the dial knob to select a different program. Otherwise run the Tub Clean program with an empty drum, it is recommended for a purpose (after 30 normal cycles). If that does not work, please contact your local LG support to get advice on your specific model.
@@LGSAE I have found that my issue only happens after big rain, when the air is very humid. I think it is messing up with the electronic. I have sent the front panel to check
Mine is just stuck on that TCL. No amount of pressing play starts the tub clean cycle
Unplug the power cord, then wait 60 seconds and plug it back in, this should wipe the memory and you can try again.
@@LGSAE I wish it was that easy
Question. I have the same issue. I buy a washing machine LG. I ran the cotton washing recommended by the manual at the first time. After finish, the console showme the error TCL. Why?
@@junama10 the Problem with mine was that some kind of liquid ran down behind the panel and severed the touch connection from the internal button, making it to be always on. Tech had to change entire front internal panel.
@@LGSAE That does not work for me - even pressing the play/pause button for 5 seconds when off to reset the programs - the play/pause button is blinking and i can't start any programs.
You accidently use the brand #TCL
Hi
I did the step but it was stuck at minute 27 and idk how to get it done realy need some help here
You may want to consult your local LG support center and discuss the situation with them.
Very useless.
Sorry to hear that. Do you mean the video does not help you to solve your issue? If you describe the issue, perhaps we can help.