Perkins 4.108 diesel engine FIRST START in more than 20 years - Jeep Willys CJ3B

Sdílet
Vložit
  • čas přidán 26. 08. 2024
  • Perkins 4.108 diesel engine FIRST START in more than 20 years.
    Ths engine has a displacement of 1760 cm³ (107 in³), 4 Cylinders in line and is naturally aspirated.
    The engine belongs to a Jeep Willys (PECJ3B version) manufactured in 1979 in Zaragoza (Spain) by “Material Móvil y construcciones de Zaragoza”, a subsidiary of CAF; licensed by JEEP CORPORATION.
    Music: ‘Bravura’ Charles E. Duble, 1918
  • Věda a technologie

Komentáře • 9

  • @lt.lasereyez8891
    @lt.lasereyez8891 Před 11 měsíci +2

    I had my boat in storage for 5 years (4018 marine version), put a battery in it pushed the fuel filter primer a few times until it felt heavy (marine version not sure your version has it) and it started up like it ran 5 minutes ago, it also cranks slower than yours, think you might have compression problems. *edit* I never use the pre heater thing as it's not needed at all unless it's way below freezing.

  • @WARD5KUSTOMZ
    @WARD5KUSTOMZ Před rokem +1

    Buddy of mine has one of these. If I can get it, it's going in my mazda

  • @timtom6402
    @timtom6402 Před 2 lety

    Very straight forward....🛵🛵

  • @balutiago
    @balutiago Před 7 měsíci

    Buen día,
    Me gustaría saber cuales son los primeros pasos para saber si el motor Perkins está suelto y que debo hacer antes de arrancarlo?
    El motor en cuestión ha estado inactivo durante 30 años. Soy de Portugal

  • @barikalor9452
    @barikalor9452 Před 2 lety

    Did you really put new pistons and rings in a old bore??

    • @BarcelonaAustinA35
      @BarcelonaAustinA35  Před 2 lety

      Hi, i used a horning tool in the cylinddr. They were within specs. This engine has no bore sleeves. Cheers

    • @douglundy5755
      @douglundy5755 Před rokem

      @@BarcelonaAustinA35 the perkins has sleeves, I thought. The parts guys all sell them. Its just like my boat engine and the starters are a stress point and Ive installed a gear driven chinese starter with a shim adapter and it works great, and reduced the huge amp draw of the old Delco starter that is about 90 pounds, also much smaller/lighter. (great old engine) Just put some warmth on it prior to starting, sit a heater in front of it for half an hour. The combustion needs this to help it light the fire, a heat gun on the cylinder head would also work. In really cold temps theyre impossible to start but when its warm they go off instantly.

  • @ToloGF
    @ToloGF Před 2 měsíci

    La chatarra esta cara ahora, estás a tiempo de venderlo al peso.