Replacing wheel hub and bearing on 2015 Ram 1500
Vložit
- čas přidán 27. 03. 2021
- How to replace wheel hub and bearing on 2015 Ram 1500.
Support my channel, I now offer merchandise.
backyard-garage-2.creator-spr... Visit my sponsors at:
superclean.com/ Super clean is there for all your cleaning needs. Super Easy. Super Fast. Super Clean.
Get some awesome LED lights at www.auxito.com
Use coupon code: BACKYARDGARAGE to get 20% off your purchase. - Jak na to + styl
Turns out the driver front driveshaft snapped inside the knuckle. Didn’t get footage of it being replaced
Ok drive shaft knockle 👍🏾
I can't believe you use the same rotor that's hilarious that thing was all crusty and crumbly and falling apart 😂
lol a guys gotta do what a guys gotta do.
You need to mention the socket sizes when applying them to the nut. Otherwise, you made a very good video.
Thank you!
Gotta hand it to you handy guy!👍
Good video! Those old Dodges are always breaking! Lol! 😂👍🤙💯 hang lose man! Good job! Lol! Love how you fast forwarded the lug nuts getting taken off! Fun and funny to watch! Zip zip right off!👍🤙💯
Left a like
im having the same issue ,I thought it was wheel hub bearing...what is that noise??
Ended up being the cv joint
The rotor edges are deteriorating. I would replace it.
👍
What size are the 3 bolts on the back holding the bearing to the axle?
I really don’t remember. I think 18mm
3 bolts on the wheel bearing are 18mm must also be torqued back on to 130 ftlbs trust me I know i just replaced mine on my 06 2wd
How long did it take to change it? I have to do that very soon.
Probably about an hour or so
Did you ever found out what it was? I have a similar truck with the same noise
Was the cv axle
How different is the rear wheel bearings to change?
I am not sure. I think you have to use a slide hammer to pull them but I could be wrong
Did you ever figure out how to do it?
@@prestoncampbell8748 No, I took it to dealer
@@prestoncampbell8748 TRQ and 1A Auto have videos on how to replace the rear bearings. I just did it yesterday. It's not difficult but you have to drain the differential and then pull out the axles on the side where you replace the bearing and seal. The bearing and seal are inside the axle and separate from the hub which is attached to the axle. If you're doing one side, you might as well do the other.
Some times things just do not go right. Sounds like brake pads or assembly not tight. Fix it right away.
Nope it was the driver side cv. It blew out the bearings and snapped in half at the knuckle
@@BackyardGarage1 As I said, some times things do not go right. Thanks for the info.
Sup?
Hi Hanzel. Seems like one thing after another lol.
@@BackyardGarage1 lol! Sure thing! Hi!👍🤙👋💯