Hi Terry, I have a N14 Celect Plus, fault codes 0434 and 0141. can you please advice me where to start looking for the problem. Truck just died on me and it cranks but not start. Position censor already replaced.
Hey Terry i work for Navistar as a tech and was wondering if you know any thing special about the old dt466 engines and anything special faults that i might come across,because i have seen quite a few roll into the shop
i was heading to the mill the other day when i started loosing power the truck shut right off i pulled to the break down lane and when i got down to about 40 mph it jumpstarted and stayed running but the truck would only do 50 it would only turn up to 15hundred if i gave it much gas it would start hitching so bad i had to let off it i got the truck unloaded changed the fuel filter it ran good for about two miles up 95 and that was it, about an hour trip home at 60 miles n hour wouldnt go any faster anyone ever seen that on a cummings 525??????????
just check the eps if it isnt feeding oil through the sensor its the ecm or some dumb mechanic has changed the point where your ecm is getting voltage usually through the starter which creates its own problems
good video... thanks
Hi Terry, I have a N14 Celect Plus, fault codes 0434 and 0141. can you please advice me where to start looking for the problem. Truck just died on me and it cranks but not start. Position censor already replaced.
2021 Cummins x15 111 343 does this same apply???
Hey Terry i work for Navistar as a tech and was wondering if you know any thing special about the old dt466 engines and anything special faults that i might come across,because i have seen quite a few roll into the shop
thank you
How you diagnose a 128 code
i was heading to the mill the other day when i started loosing power the truck shut right off i pulled to the break down lane and when i got down to about 40 mph it jumpstarted and stayed running but the truck would only do 50 it would only turn up to 15hundred if i gave it much gas it would start hitching so bad i had to let off it i got the truck unloaded changed the fuel filter it ran good for about two miles up 95 and that was it, about an hour trip home at 60 miles n hour wouldnt go any faster anyone ever seen that on a cummings 525??????????
I have two fault code plz let me know this code first one is 0245
And second is 0289 plz let me know what i need remplace
What are codes 97 and 100? No one seems to know!
I"m getting. a 235 code
just check the eps if it isnt feeding oil through the sensor its the ecm or some dumb mechanic has changed the point where your ecm is getting voltage usually through the starter which creates its own problems