Two Ways To Change Working Position On Hydraulic Jack Horizontal and Vertical Working Position

📢 #HandmadeCreativeChannel📢
📢 Subscribe My Channel - / @handmadecreativechannel 📢
Hello friends, today I will show you Two Ways To Change Working Position On Hydraulic Jack Horizontal and Vertical Working Position
In this video clip I will show you a simple way to reverse the working position of a hydraulic jack. In both projects, I will use a small copper pipe that I will clamp into the base of the hydraulic jack.
I hope you like the projects.

[@gilsonfelix3415]

Fantastic, I always thought that the jack to work horizontally needed to be manufactured for. Thank you.

[@OliverlifestyleJa]

Awesome job my brother, well done 👍

[@triggerhappy8872]

Good idea dude 👍👍

[@michaelnovak9766]

The copper pipe added , works at the lowest point when in operation. Plus one is never going to operate the jack with no oil. So the concern added won't be a issue. The only thing I would consider is using a slightly oversized inner hole diamater aluminum or copper washer on the oil plug bolt, that the o ring seal he added will locate internally in for a better seal on the vertical modification one 🙂

[@TheGathumpus]

Will the other holes/inlets that are not piped suck air if the oil level drops to low, or in the case of upside down all the time?

[@saburoy3311]

Yr doubt is genuine
In both positions air will go in and won't function properly

[@perezoso44]

Como va fincionar si dejaste abierto