Gen 1&2 4G63 timing belt tension
Vložit
- čas přidán 26. 08. 2024
- I had tried other methods found on similar videos and found most of them are stupid asses and ignore the simple fact that there is a easier way to do this process and no sense to make it more complicated than it needs to be.
Excellent video - that important point about the pin being easy to pull out (being the indication of correct tightness) is a detail completely glossed over by all the other videos on setting the timing belt tension. Without taking that into consideration, the belt could be too lose or too tight.
Holy shit, thank god for your vid, Makes the damn procedure so simple
thanks for the example of the loose belt. thumbs up just for that alone.
You have balls to start it on a loose belt Jesus Christ.
Its for the content :D
So if installing a new hydraulic tensioner and belt you don’t need the long tool? Just the tool to tighten the pull and make sure the grenade pin is loose and that’s correct tension? Cheers for the vid
Many thanks for info and help !!!!!
Ролик натяжной не в ту сторону натянут, против часовой стрелки он натягивается. Не оборвало ремень то ещё?
Friend then change the strap my engine got the relenti inserted what can be?
Just wondering I took the timing belt off, before aligning the cam gears. And went on to turning the gears individually to aligned the timing marks to top dead centre. I may have turned the exhaust gear fully clockwise twice and the cam gear fully clockwise only once to align the timing marks, will my gears stu be tdc?
Is this the same for the 4g64 block with the 2.4L motor with the the pin going in and out easy?
Robert T no sure on that one. The tension is the same but may have a different tensioner.
¿What is the size of screw for the tensioner pulley?
The second hole where my grenade pin goes in is turned sideways and doesn't line up with the hole where the grenade pin first goes in. Do I just need to buy a new auto tensioner? Or is this fixable?
Jesse B no stick the grenade pin in the hole and twist it straight.
Jesse B the part turns. The the grande pin to turn it back into alignment then try again.
Can you just tighten the pully without messing with the other tensioner
Jordan W Theoretically yes because the tensioners hydraulic however before you tighten it you must roll them over backwards this one sure that the tensioner as far out as possible and then tighten everything down
Tensioner bearing 180 out of
i set my timing belt with grenade pin going in and out..driving car about a year...put a see through cover on it.when i rev it hard looks like the belt has a little wobble up and dwn between the cams..is this normal?.
Dirty Harry yes that is normal.
Dirty Harry where did you find a clear cover for it?
Sometimes the belts look loose but these belt back lash. You need that to help keep the belt cool and prevents snapping, tight belts run much hotter.
this video shows no belt wobble czcams.com/video/17Zl2dZDdqk/video.html
If it's too tight what are the symptoms?
John Lucero if it’s too tight the belt will walk off the pulleys and it may make whining noise. The temp of the belt will also be hot. Some of the aftermarket pulleys are slightly larger. It will feel tight but the belt may actually be hitting the pulley.
Clinton Massey isn’t you’re making a whiney noise when you rev it at the end???
It can also eat your oil pump gears I believe if too tight
Nice bro...✔️👍..sub