Installing an Electronic Fuel Pressure Gauge

DISCLAIMER: These videos show my way of doing things. Don't necessarily follow my advice, I could be wrong. You are responsible for your actions. Not me.
Installing an in-cabin fuel pressure gauge.
Parts used below:
AutoMeter 3363
AutoMeter Gauge Cup 2204
Russell Take-off Fitting RUS-670343
Summit 1/8” NPT nipple SUM-220670B
Vibrant Performance elbow 11320
The other parts (like the adapter and the mechanical gauge) I already had so I don’t have the part numbers, but the port on the Fitech is 9/16-24. I used an adapter from 9/16-24 to -6an. Parts are easy to find at Summit.

[@chrislopez6185]

Did this to my car. Great video

[@JPVSR]

can you provide a parts list? I would like to replicate your setup. Thanks!

[@JPVSR]

Also if you have a parts list for your under the hood setup I would greatly appreciate that as well.

[@mechtrician1]

I will post the parts used in the description section later today.
The gauge comes with the sending unit as well. So it’s basically the gauge and fittings. I’ll get it posted up.

[@JPVSR]

@@mechtrician1 You Rock!! Thanks again.

[@mechtrician1]

@@JPVSR no problem, it’s in the description now.

[@JPVSR]

@@mechtrician1 what about the sender/pressure transducer?