Aruba Wireless controller | Basic Installation and Configuration | AOS 8.8

In this video tutorial we are doing basic configuration of Aruba Wireless controller Firmware version 8.8
using Aruba 7010 single controller and Access Point - AP503H model

[@JKStillwaters]

Thank you very much for this video.
~from Sri Lanka /Maldives

[@tamoorali9065]

i have actualy worked on aruba projects and no need to convert each access point to campus access points basically the aruba have campus access points models you just plug them and connect them through the vlan which you add them on the switch and they will once reach to dhcp server for getting ip address the dhcp server provide them their ip and controller ip so they directly take configuration from controller on which you already add them by their mac-address by yourself manually.

[@zahidpervez5000]

very good effort

[@network3604]

Thanks a lot

[@tamoorali9065]

great

[@user-qv5nn7nl5m]

Hello, can i use the same controller on the IAP-207-RW and the latest Aruba APs?

[@ichsanananto4651]

Hello bro thanks for the video so good, btw how to reboot ap using schedule on mobility controller ? Thank you before

[@network3604]

Hi , can you please tell me your use-case , do you want to reboot all the AP's or it possible to reboot controller in scheduled manner . how is your infra , do you have any management software like airwave or IMC and do you using HPE switches ?

[@zahidpervez5000]

Dear do you have further advance video of aruba controller

[@tamoorali9065]

good

[@prashantsaindane4848]

Can please upload more videos
For troubleshooting

[@FreeTechandGiveaways]

Question:
DSCP
1-Device Wi-Fi Mac address showing "not found" in access controller
2-Searching through IP Address showing different MAC & location
any solutions ?

[@zahidpervez5000]

Dear if we are using stand-alone
WLC do we need router or ISP provided router will be fine?

[@network3604]

If this setup was only for Guest then ok , if you are using above setup for your organization better to deploy Firewall on the Perimter . or you have PEF license you can configure firewall in Aruba WLC.

[@LupizkaAlvarez]

Can u please tellme how to set enable password and quit the * on the controller by ssh.

[@shuihaibshadulyponnan2155]

hello, how can we add a additional controller for failover?

[@iti-expert]

Have you found the answer? )

[@iti-expert]

czcams.com/video/Y5K0x8GQOeA/video.html

[@santoshkumarkori8142]

how can change controller IP address from old to new

[@network3604]

you can change controller ip - go to CLI--> show switch ip , CLI-->sh ip interface brief
cli output verify VLAN ID using for the switch IP.
after that goto config mode change IP address of the VLAN
do write memory
after changing reboot controller .
preferred way of changing switch IP through console port