How to Replace Crankshaft Sensor 2007-2015 Mazda CX-9

Buy Now!
New Crankshaft Position Sensor from 1AAuto.com 1aau.to/ia/HTEC...
This video shows you how to install a new crankshaft position sensor on your 2007-2015 Mazda CX-9. The crankshaft position sensor is an important component of any electronically controlled ignition system. The sensor provides the computer with data about the position of the crank shaft to properly adjust ignition timing. If the sensor in your vehicle is broken or malfunctioning, you may suffer poor performance, or get a check engine light.
This process should be similar on the following vehicles:
2007 Mazda CX-9
2008 Mazda CX-9
2009 Mazda CX-9
2010 Mazda CX-9
2011 Mazda CX-9
2012 Mazda CX-9
2013 Mazda CX-9
2014 Mazda CX-9
2015 Mazda CX-9
Tools you will need:
• Pry Bar 1aau.to/oMq/1AX...
• 10mm Socket 1aau.to/oaVp/1A...
• 14mm Socket 1aau.to/obdQ/1A...
• 15mm Socket 1aau.to/obdQ/1A...
• 7mm Socket 1aau.to/oaVp/1A...
• O2 Sensor Socket
• 1/2 Inch Impact Gun 1aau.to/opx/1AX...
• 3/8 Inch Impact Gun
• Ratchet 1aau.to/obpw/1A...
• Socket Extensions 1aau.to/obdQ/1A...
• Torque Wrench 1aau.to/oatv/1A...
• Anti-Seize Grease
• Bungee Cord
• Floor Jack 1aau.to/oVb/1AX...
• Hammer 1aau.to/oPx/1AX...
• Jack Stands 1aau.to/oNV/1AX...
• Pick 1aau.to/oIm/1AX...
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@joegutshall4321]

That's not a crankshaft sensor....you working on the transmission speed sensor.... The crankshaft sensor is bolted with 2 bolts on the balancer....

[@elDoober]

Holy rust Batman! Idk how people live up north with all that rust!

[@CandyMalpicaOfficial]

How do you calibrate it after puting on the sensors ? Thanks

[@user-fj4bt7uw3r]

Any chance of this being down on ramps, sans lift?