Security bypass when installing a new ignition on a 2001 Chevy S10. Not the most pores suck all way of doing things but it gets the job done. Comment any questions, glad to help
Does that security light stay on the dash when security system is bypassed? Also do you have to keep repeating this process everytime you normally start the truck or just only when you had to splice the wires?
So if you bypass the security why did you have to do the sequence to reset it if it was bypassed and you only have to do the sequence once most of the time
my issue is I get not crank or anything from my 00 s10 2.2. while turning the key to start I have no power to the "S" wire. I replaced the Ignition switch but still nothing
I'll. Be damd if that didn't work for me. I had to do it a couple times but the third time it worked. Really appreciate it good job younster
Yu the man bro!! When yu said “it starts but turn off immediately” that’s how I knew this was the right vid!
Great video straight to the point without a lot of sh$# i don't want to or need to listen to well done 👍
Currently trying this right now.
I'm going through the same problem, will try your method! Hope it works! Thanks for sharing!!
Best of luck!
@dallasmcalpin3573 hey buddy, just to really preciate your video it did work 👍! Thanks so much 🙏! And God bless you!
Worked like a charm thanks
So it works?
thanks for the info thats what was wring with mine
So it works?
Great video by the way
Does that security light stay on the dash when security system is bypassed? Also do you have to keep repeating this process everytime you normally start the truck or just only when you had to splice the wires?
Sick!!!!
Hell ya, Thank you!
Glad it helped!!
it worked thank you!
Can you do a video on a Honda Civic next ?
And on the first time do yo wait till it stops blinking or only on the second and third
Dood you stole that truck didn't you 😂jk
Stole it and immediately posted a hotwire trick to CZcams!!!!!!!!😂😂
Will this fix the problem if my dash says unknown driver
So if you bypass the security why did you have to do the sequence to reset it if it was bypassed and you only have to do the sequence once most of the time
One more question what if it’s a copy of a key
my issue is I get not crank or anything from my 00 s10 2.2. while turning the key to start I have no power to the "S" wire. I replaced the Ignition switch but still nothing
Check your engine fuse. 40amp
@@FastenDeezNutz all those are good. I think it's the fuse box itself. from where the purple wire goes too
Did you figure it out?
@@junioravj9050 fuse big 40 amp crank start ign fuse.
@@junioravj9050 under the hood
Soo 3 times???
2 bright wash out 😂
If you start it to early do you have to repeat the process
Probably
Have to do it until the security light stops blinking .
Would this work on 2001 chevy silverado?
Probably if the wiring is the same. It worked on my 1998 Chevy 3500.
The security light stays on after that permanently?
I think it might. I don’t recall though
I’m out here struggling
Lol
Would if the security light stays on while driving I have a Chevy blazer 2000
Idk, but I just waited until the light went out so I guess just try and wait till it goes out
I have a 2000 blazer thinking about trying this does your light stay on all the time
Also did it fix it
@@jamesmurphy6163 its work ?