Peugeot Expert P20E8 Pressure of the urea fluid too low fault fixed
Vložit
- čas přidán 15. 05. 2024
- Investigating and fixing an ad blue fault on this 2017 Peugeot Expert 2.0 diesel van. ad blue and spanner warning lights on dash, engine fault message on the centre display. P20E8 pressure of the urea fluid too low fault recorded in the engine ECU. fault caused by a failed ad blue pump in the tank, fault rectified by replacing the complete ad blue tank.
New complete ad blue tank - ebay.us/WOOeLA
Diagnostic machine used:
Topdon Phoenix lite 2 - diydaly.co.uk/...
Budget EOBD scanner - ebay.us/zVNaLk
Advanced EOBD scanner - diydaly.co.uk/...
Tools used :
Screwdriver set - ebay.us/W79UkN
Vertical jack - ebay.us/j3wCqb
Socket set - ebay.us/DjgPPj
Milwaukee impact driver 3/8 - ebay.us/ZtxrBu
Check Euro car parts - tidd.ly/3lIO7xA (use discount codes on site)
Check GSF Car parts - tidd.ly/34pZe7o (use discount codes on site)
Any Donations to help Support my Channel are much appreciated.
Donate via Paypal - paypal.me/diydaly
Useful links:
Car Analytics - Vehicle information checker - tidd.ly/3B2PEbx
If you found this video useful, please Like Share and Subscribe to help grow the channel, and never miss any future content. www.youtube.co...
Please also check out my website - www.diydaly.co.uk where you'll find top quality goods, tried, tested and recommended by actual mechanics.
DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. This doesn't effect the price you pay! - Auta a dopravní prostředky
ACCOMPLISHED, DIYDALY
👍
From Nick Ayivor from London England 🇬🇧 ⏰️ 20:10PM Good Evening
Hi there, just some advice after watching your video: I have a Peugeot 308 2.0 blue hdi, 15 plate. Firstly whilst on motorway it started with the stereo said it was overheated and the volume went down from 29-15 and would go up( might be a thing) then 5 minutes later ‘engine fault repair needed’ then ‘ emissions control fault’ came up , car felt lumpy at 55 mph and shakey ( like wheel balance) but better at 40.break down came out and cleared P20E8, I’ve driven it for over 15 miles and no codes have appeared but still runs lumpy / out of sink, some say to clean NOX sensor ? What do you think… ps I am due a service 👍thanks
Wouldn’t go up stereo ok now
Very hard to say on that one without looking! Are there no fault codes? Nox sensors won’t cause it to run rough
@@diydaly thanks ; just done 60 miles no codes at present, I’m thinking if it was the pump on the adblue tank then the car would smoke. Just going to get a service and go from there thanks
Hi, would AdBlue Delete also fix this issue?
Where are you based do you offer diagnosis?
👍👍👍
Thanks mate
They all fail at “Mr Default” or time or miles 🤬