Yes, it is more difficult to start, but it gains power, be careful not to overdo it as it can damage the engine. With the delayed ignition timing it is easier to start and with a smoother behavior and gives more durability to the engine. never go far from what is recommended by the manufacturer.
@@douglasguido6627 It will gain low end power but loose out on peak power. A retarded timing will give less low end power and a mellower engine but more top end power at high rpm.
If I read this right You piston has to be .02 smaller than your jug if not you will have a 4 corner Seizure. .04 to .05 you need to go up in size of your piston. A 53.94 B 53.95 C 53.96 D 53.97 Some pistons are different sizes
Entonces lo dejo en la misma raya el rotor o lo pongo como la tuya un poko más atrás de la Linia
Feel free to ask
How wpuld you set timing after a rebuild, i didnt make marks on the stator or anythi g before splitting the cases, does that make it alot harder ?
Just line your marks up and your good To go.
Line on case and line stator
Sir. How many degrees is yz 125 2000 advance timing?
. 019 to .021
They came .019 to .021 Thousands advanced after top dead center with stock timing marks
Will advanced timing make the bike hard to start?
Yes, it is more difficult to start, but it gains power, be careful not to overdo it as it can damage the engine. With the delayed ignition timing it is easier to start and with a smoother behavior and gives more durability to the engine. never go far from what is recommended by the manufacturer.
No
@@douglasguido6627 It will gain low end power but loose out on peak power. A retarded timing will give less low end power and a mellower engine but more top end power at high rpm.
hello i need piston cylinder where can i get it
If I read this right
You piston has to be .02 smaller than your jug if not you will have a 4 corner Seizure.
.04 to .05 you need to go up in size of your piston.
A 53.94
B 53.95
C 53.96
D 53.97
Some pistons are different sizes
@@250race en esa posición tiene k esta el encendencido eske tengo una igual y yo la tengo en la misma raya aber si me podrías ayudar
@@isaacserranoroa438
?
Lo dejo en la misma pocision k la tienes tú o lo dejo en la misma raya con raya del rotor