Internet First? Allis B10 Diesel Swap!

In what may be an internet first, watch as I integrate a knock-off single-Cylinder diesel into an Allis-Chalmers (Simplicity) garden tractor. #allischalmers #simplicity #gardentractor #diesel #b10 #bigten #landlord

[@oreilly3592]

Awesome job!

[@timothybaker682]

That fit really nice. Turbo it next???????

[@PaulHigginbothamSr]

So the flat plate needs rubber grommets to attach to the motor. Also the engine needs rubber engine motor mounts to keep from breaking all the welds in the tractor frame. Helps with hand vibration on the steering wheel.

[@firefly3333]

Hmm. I don’t notice a lot of hand vibration unless I’m trying to see how low it’ll idle. For now it’ll have to ride along and see what breaks… I can re-weld and re-enforce no problem… but it’s a lot bigger deal to raise the motor enough for suitable rubber grommets… have to make a u-joint driveshaft, and any higher I risk interfering with the steering shaft.

[@gernestpeters7603]

5 minutes of rather useless chat till we get to the meat of the video and then it's just basically pablum. I was expecting to learn something for the time I spent watching. I was disappointed..

[@jadenwilliams6330]

How about if you don’t like the video don’t watch it and quite hating on small creators we are meant to support them.

[@gernestpeters7603]

I watch these videos to learn something. I'll gladly support content, after all I watched the video!! But I was more than a little cheesed that in my opinion it was a waste of time. I thought I had toned down what I wanted to say to a polite level but obviously we don't agree. All the best to the video content creator....