Yamaha FJR 1300 front fork disassembly / oil and seal change / teleszkóp olaj és szimering csere
Vložit
- čas přidán 26. 07. 2024
- Yamaha FJR 1300 első teleszkóp javítás, teleszkóp olaj és szimeringek cseréje.
Yamaha FJR 1300 front fork repair, changing the oil and the seals, cleaning the fork inside. - Auta a dopravní prostředky
Thanks for sharing this. I am doing my seals and I will be following your sequence.
Thank you for watching my video!
@@latzkoworks I appreciate you doing it mate. It's really important to put the forks back together in the correct sequence, and your video is clear and precise.
Hi if you can give me advice much appreciated, I am.doing this job ,I removed the upper fork from the bottom exactly like you did it ,both bush ring came out ,the washer and the seal ,but when I try to clean the bottom piece another 3rd ring bush came out .......only asking because on your video I can see only 2 bush rings
Hello, yes, in some types there is one more bushing ring, so one on the inner tube end and two at the top of the bottom part.
@@latzkoworks thanks yes after 2-3 hours I understood it ,on gen 2 2007 there is 3 bushes ,the 3rd one is rest in the middle of the bottom piece..... thanks
You are right ✌️
Hi, I saw your videos about fjr front forks, You are using a repsol 5 w ? Is not a 10w? In My bike I using a 10w and is so soft..
Hello, in the repair manual was written the 5w. The original springs used to be too soft after time.
@@latzkoworks Hello, thanks for your answer, yes, it could be the springs that are tired, I have a problem with the starter motor, could you show me how to get to it to remove it?
@@latzkoworks you already have one more subscriber😄😄
@@alvarosilva8077 thank you 😊
@@alvarosilva8077 about the starter motor: I can't tell you anything, I did not removed it from this bike.
What year is this bike? I'm my forks are stuck and I can't remove them to replace the bushings on my '06 Fjr!
Hello, as I remember it was from 2003.
Same here. Got it unstuck. Did you put all 3 bushings back in or did you leave the middle one out.
Hello, I have only replaced the sealing, have put all the original parts back.
I'm struggling to get the bolt back in the bottom of the fork. Is there something that I'm doing wrong.
I have an fjr1300
Hello, nothing special. Just install the inner parts in the right sequence, hold all them horizontally, and push them together. After that you should lift up a little bit the upper end, and turn the bolt in.
@@latzkoworks thanks. I'll try again