I took mine apart to clean out well and to also do the skeleton mod. But now when I put it back together it trips the GFCI outlet. I’m afraid of using them now and getting shocked 😂 What do you think I did wrong?
Check if your cord is strip off and rubbing on the iron inside the clipper. Sound like the negetive or positive both meeting without a cut off eg. The switch
Thank you for this guide
please subscribe
Love the video bro, I never went so far in loosing up the T-outliner
Thank you
I had problem setting back the switch contact
OK it's a little tricky
Can you help me understand why my liners aren’t powering on? I was disassembling and the red wire isn’t getting juice. Any ideas?
Did you check the switch or there is small wire and the side of the coil if that is broken then there will no power
I took mine apart to clean out well and to also do the skeleton mod. But now when I put it back together it trips the GFCI outlet. I’m afraid of using them now and getting shocked 😂
What do you think I did wrong?
Check if your cord is strip off and rubbing on the iron inside the clipper. Sound like the negetive or positive both meeting without a cut off eg. The switch
I have trouble putting that oval thing with a curve at the tip
let me know which part of the video if its the what we call the tongue that moves the blade
it's not difficult to put back on
In the video you didn’t show where you put that oval thing with a curve
which oval thing
I cut mine ontop and changed the blades and set the cords on the side and it still shocking
Shocking as in current. When you closing the clipper look in it if the cord is resting on the metal part of the clipper