Hi, if you were fitting a triple rear seat what brackets would you use? Is it the simple L type brackets or the brackets which sort of frame around the cross beam?
Hi Eddie, Fitting a bench triple in the middle row requires the larger type brackets. The smaller L shape brackets are used on the far outside brackets of a 2+1.
Thanks, I'm wouldn't know to be honest as we only install genuine VW Belts. The genuine belts are designed to go in this location and the spools have the correct mounting bracket to install in the vans bodywork. (there is a notch out for it to sit level). I would recommend factory bell and reinforcement plates only!
@@VanCreations thanks for your reply. Have ordered genuine VW. What is the measurements for the c pillar plate. I have a swb single side door. Hope you can help
If you haven't already please subscribe to our channel here czcams.com/users/vancreations We have lots of new content coming soon!
Thank you for your video. You made it so clear how everything should go
Thanks! I hope this helped explain the install. We try out best to make it as easy as it can be! Good luck!
Simon - Van Creations
Awesome, thanks for sharing 👊🏼
No problem 👍 I hope it helps!
Thnx! Very useful video!
You're welcome!
Hi, if you were fitting a triple rear seat what brackets would you use? Is it the simple L type brackets or the brackets which sort of frame around the cross beam?
Hi Eddie, Fitting a bench triple in the middle row requires the larger type brackets. The smaller L shape brackets are used on the far outside brackets of a 2+1.
Great vid. I been looking at the universal three point belts. Would these fit ok do you know?
Thanks, I'm wouldn't know to be honest as we only install genuine VW Belts. The genuine belts are designed to go in this location and the spools have the correct mounting bracket to install in the vans bodywork. (there is a notch out for it to sit level). I would recommend factory bell and reinforcement plates only!
@@VanCreations thanks for your reply. Have ordered genuine VW. What is the measurements for the c pillar plate. I have a swb single side door. Hope you can help
Also you said the seat belts are sided. How do I tell?
255mm down from the ceiling line, it’s in the video when I set up the laser to demonstrate!
easiest way is to google the part number on your belt retractor unit and it will state left or right!
Hi, can you tell me what size pop rivets you used please?
Hi, 4.8 x 16mm or 5.0 x 16mm will be fine.
Simon
@@VanCreations Thanks Simon. I have 4.8 x 14mm stainless steel rivets. These should be fine!