Fairlane RestoMod: Episode 4 - Floorpan rough install

Floorpan rough install. There is still some finessing to be done when I get to the underside.. mostly pinholes and thin metal.
Comments will be in the Closed Captions track
Before I get too much scrutiny, I am by no means a sheet metal expert. I wanted to do butt welds to minimize appearance of the repair, so this was first for me. I will defiantly be paying for my lack of skill later when I fill all these holes from the back.
The passenger pan was done the the hard way. I discovered Fitzee's Fabrications just after I did that pan and it is a game changer. His method is FAR superior to the hard way. I still did not master his method, but it is a quantum leap from the first pan. In fact, you should stop watching this and watch all of his videos!
/ @fitzeesfabrications
All that out of the way, be gentle! This is not a "how to" - I am also improving my skills.

[@Lifeistooshort67]

Perfect. Keep up all the hard work it will all pay off with that first burnout! I have a 1967 Fairlane. Had it since 1989. I put 175,000 miles on it since then for a total of 264,000 miles. I will probably have to do much of this to mine, one of these days but for now I will just drive the wheels off of it. Lol

[@67fairlane12]

Hey Great job! You had the balls to start it and finish the floorpans. The biggest step is to just start. i did the same thing 3 years ago. never looked back and i love it!!

[@sammy9452]

You know where to get the sheets metal that hold gas tank.

[@eythanholladay]

I do not... that is likely a part that would need to be fabricated. You may be able to start with a mustang patch panel, but the bit should be easy enough to scratch build.

[@sammy9452]

@@eythanholladay Thanks

[@hotbeerjosh9019]

Floor looked fine before!

[@eythanholladay]

true, I have seen worse, but it is done now!