Step up your game with Steady Cast & 24xd
Vložit
- čas přidán 21. 08. 2024
- Learn what is needed to improve your waypoint and heading accuracy for your Garmin units.
Steady Cast Heading Sensor
www.russellmar...
Garmin GPS 24xd GPS
www.russellmar...
PURCHASE BTR MERCH HERE
behindthereelf...
FAVORITE JIG
www.bizzbaits....
Check out the F5 Ghost Code Tournament Series
www.f5rods.com...
Favorite Polarized Glasses
Use code BTR to save 15%
www.waterlandc...
#fishingshorts #fishing #fishingvideo #catchandrelease #bassfishing #bassfishingtips #bassfishingtipsandtechniques #skeeterboats #fishingtournament #fishingvideo #largemouth #largemouthbassfishing #bassforbeginners #bassfishinglures #bestbasslures #fishingvideo #spawningbass #largemouthspawn #jigfishing #hookset #largemouthbass #largemouthbassfishing #swimbaitfishing #swimbaitunderground #swimbaituniverse #bigswimbait #glidebait #jigfishing #texasrig #crankbait #squarebill #catchandrelease
Great video. I've wondering how this would work for my hobie. I looked at the steady cast, but I wasn't sure what all I needed. This video helped a lot!
You could go either way on the hobie but the steady cast would be sufficient in my opinion!
Man I just dropped my favorite fishing pole in the water yesterday super bummed
I just recently installed the 24xd on my fishing jet ski. All the calibrations seemed to go well. The gps accuracy is great but sometimes if I’m going slow it has my boat/heading 180 Degrees flipped around.
You might try calibrating again. Check and make sure your nmea backbone is installed correctly as well. Check all t's and end caps
I have both and the 24xd is setup already. Still need to install the steady cast. My question once how do I set both up on my 106sv? Do they run simultaneously?
I would install the heading sensor up front for your bow units and the 24xd in the back. They will both run thrush NMEA 2000 and you will be able to go under your GPS source and select them accordingly. Holler if you have any questions. 316-313-4113 ext 407
Can the 24xd be setup on the dash of my 18' open boat with a full windshield next to my echomap.
Hello, do you mean do I need to purchase both? According to your video, is it true that GPSX24D can only choose one function between GPS signal source and direction indicator? This seems a bit strange?
No. If you choose the 24xd you will be sourcing the antenna as well as the heading sensor. You can run just one but you will not want to use the same antenna for both bow and console units.
great video man!
I have the 24xd and am wondering if the directional circle available on the Livescope screen will utilize it? I am pretty sure it will now work with the Steadycast now. Won't be able to validate for a few more weeks on my boat.
You should be able to source the heading from the 24xd but I believe you will also be selecting it for your GPS antenna by default. Depending on where your 24xd is located that could be a problem.
I have a UHD2 93 sv at the bow and helm, i need the 24xd on the transom and steadycast at the bow, correct?
Yessir!
What happens when you make a waypoint at the bow. The front unit will use the internal GPS correct. So waypoint accuracy is diminished?
@michaelborcky6995 it will be pretty dang accurate since your bow mounted transducer is almost directly below your unit. At the transom there is 6+ ft room for error on a typical bass boat
Hey, I have 8600 xsv’s and the accuracy per the display is 10-20 ft depending. I’d like more accuracy if possible, but I’m wondering if the 8600’s have better gps positioning and if the gps 24xd will help with that
If you (only) install 24xd, what will it do on your chart? If you (only) install steady cast what will it do to your chart? Why need both?
You will not want to use a 24xd for two units that are on opposite ends of the boat as this will be your source for marking waypoints. If you just want to fix your heading you can get away with a single steady cast.
Thanks for the video..
I have the 24 now, do you think I’ll get an added benefit with adding the steady cast?
I see guys use 2-24xd’s
I’m wondering if that would that would be the same as adding a steady cast..
Garmin had many different points of view on this
Lol
Any help would be appreciated
Thanks Kurt
Steady cast up front and 24 in the back would be just fine. Not much benefit to a second 24.
@@BehindTheReelFishing
Hay man
Thanks for the reply and again for the video and the input…
I get the 2-24’s being over kill,
Just confused about the benefits
Of 2 heading sensors, but I’m gonna put one in and see
Lol
@kurtgould7821 you just can't select the 24 as your heading source without also using it as your GPS source so you will automatically mark waypoints from it. If it's at the other end of the boat your waypoints would be way off.
안녕 친구
24xd와 스티드케스트는 기능이 다른다는건가? 지금 카약에 122sv 사용 중인데 이 두가지를 모두 장착해야 되는건지 궁금해
Can any of these devices be shared between brands? I have both Garmin and Lowrance.
No they cannot. You will have to have 2 NMEA 2000 networks
Ugh, Garmin should have made the steady cast with a Cat5 cable so it can go into their hub! So if you buy the SteadyCast you will have to spend an extra $100+ to run it and then an extra $50+ for each additional graph 🤦♂️
Yeah, but that's pretty standard across all brands now. The only one not using NMEA 2000 is Humminbird and I'm sure they will be switching over as well.
They wont
plug into the GMS 10 hub?
No. You will have to establish a NMEA 2000 network if you don't already have one.
@@BehindTheReelFishing Bummer! Thanks