Beko fridge repair - replace temperature sensor

Sdílet
Vložit
  • čas přidán 25. 03. 2022
  • Remember that fridge electronic components are under high voltage !!! Before you try to repair it and replace temperature sensor swich off the power.
    Solder joints must be insulated with a heat shrink tubing!
    The fridge freezer that I had repaired kept cooling all the time, and didn't turn off. The malfunction of the fridge freezer is often caused by a damaged temperature sensor. It's an inexpensive item.
    Replacing temperature sensors is simple if you have a minimal understanding of electronics and are able to solder. I's also possible to buy a sensor with a suitable plug so there is no need to solder. The biggest problem is usually finding these sensors. In the video, I showed how to get to the Evaporator Sensor. Unfortunately, the thermistor is not where I expected it to be. I decided not to waste time and to tear any more thermal insulation. I put the new sensor against the metal plate on the back of the refrigerator. It works! If it still did not work properly, I would replace the sensor in the Evaporator.
    I used the sensor with the symbol 4394720285
    *******************************************
    - If you enjoy my content and like to support me then I’d be so grateful for a virtual „coffee“. Any amount is welcome and goes a long way to keep me going. Thank you. www.buymeacoffee.com/knemo
    - I'd love to hear your thoughts. Please comment, like and let me know what you'd like to see next.
    Subscribe for the latest videos: czcams.com/users/knemo?sub_confir...
    #knemo #repairs #fridgerepair #beko #brokenFridge #fridgeFreezerRepair
  • Jak na to + styl

Komentáře • 44

  • @Theboywiththedrone
    @Theboywiththedrone Před 2 lety +1

    I"m happy to be back here with you on the cannal 👍👍🙋+full

  • @unfocusedjoker4374
    @unfocusedjoker4374 Před měsícem +1

    My fridge freezer is a Beko model CCFM1582W. Is the thermostat in the dial/light assembly located in the top of the fridge? If so how do i get this assembly out? Its too cold! Any help would be much appreciated thanks

  • @sciencesurgery6878
    @sciencesurgery6878 Před rokem +1

    @k-nemo
    Thanks for the video, when you say "I put the new sensor against the metal plate on the back of the refrigerator" do you mean the back of the freezer section (ie what you show in the second part of the video)? Thanks

    • @k-nemo
      @k-nemo  Před rokem

      1:37 back wall of the upper chamber

  • @LockheedStarliner
    @LockheedStarliner Před 6 měsíci +1

    Good video. You need to correct the brand name in the title to Beko.

  • @adam3rdcanvey
    @adam3rdcanvey Před 2 lety +2

    Great. What are the symptoms that leads to sensor replacement please? My fridge is running at around 10 degrees. Freezer fine..thanks

    • @k-nemo
      @k-nemo  Před 2 lety +1

      Read the description of the film please

    • @adam3rdcanvey
      @adam3rdcanvey Před 2 lety +1

      @@k-nemo That was great thanks

  • @user-sd1ed8ig1y
    @user-sd1ed8ig1y Před rokem +1

    В каких моделях беко такое расположение датчика? И бывает ли два датчика температуры? Могут ли они находится один на боковой стенке под колпаком а другой в испарителе запененной части? Это я спрашиваю про холодильный отсек.

    • @LockheedStarliner
      @LockheedStarliner Před 6 měsíci

      translated ........In which Beko models is the sensor located? And are there two temperature sensors? Can one be located on the side wall under a cover and the other in the frosted part of the evaporator? I am asking about the refrigerator compartment.

  • @PavanVarma369
    @PavanVarma369 Před rokem +4

    Our top compartment is not getting cold. Only the freezer is working. What could be the reason?

    • @paulb9769
      @paulb9769 Před 11 měsíci

      Solved?

    • @SY-yk5gb
      @SY-yk5gb Před 10 měsíci

      Same here. Found a reason?

    • @jamesforrester2478
      @jamesforrester2478 Před 3 měsíci

      Hi, the problem you are likely having is short of refrigerant.

  • @zabihullahpir4766
    @zabihullahpir4766 Před rokem +2

    Hi
    My beko fridge freezer
    The top part is freezing as well
    I check the temperature sensor with Multimeter it is showing resistance but still it is freezing ?
    Any idea please what will be the problem ?

    • @thedevilsreject23
      @thedevilsreject23 Před 5 měsíci

      Could be the pcb board but unlikely to be - cheap enough to replace the small internal one by the light inside - the rear one is about £30 roughly

  • @gamingkingX
    @gamingkingX Před rokem +1

    Is it the old or new sensor you test at the end?

    • @k-nemo
      @k-nemo  Před rokem

      New. I couldn't find the old one.

    • @gamingkingX
      @gamingkingX Před rokem

      @@k-nemo thank you.

  • @fdsfsdf9180
    @fdsfsdf9180 Před rokem

    how do you where thermistor was placed? besides I didn't notice the original one.
    I have exact the same problem with my whirlpool fridge. It seems to be broken, so I have to detach it. I put a new thermistor inside the fridge against the back panel (the controller and pcb plate are inside, so it's ok). the upper chamber temp is ok but in the freezer it's too cold (about -13F). I think that is because the evaporator temp is lower than the back panel inside the fridge. I'd replace the new one to the stock position removing the insulation but I don't where it actually is and the scheme is too obscure to find it. thanks.

    • @k-nemo
      @k-nemo  Před rokem +1

      I couldn't find a thermistor. There is information in the description of the video.

  • @MrMarkalroberts
    @MrMarkalroberts Před 3 měsíci +1

    I have exactly the same problem with my beko. Had it’s for 10 years and suddenly it’s freezing all my vegetables!!! Would be super useful to have a link to parts that could be bought but anyhow thanks so much for this video
    Will not buy another beko. They should make this a replaceable part. Pretty unforgivable really.

    • @k-nemo
      @k-nemo  Před 3 měsíci +1

      I bought it in some online store. I provided the type of refrigerator.

    • @MrMarkalroberts
      @MrMarkalroberts Před 3 měsíci +1

      Thanks! I have ordered exactly the same part number.... will see if I can it work like you did 🤞🤞🤞

    • @MrMarkalroberts
      @MrMarkalroberts Před 3 měsíci +1

      It worked! Beko ff6091x was the model of fridge, and its now saved from landfill thanks to this video. Thank you so much!

  • @diegofantoni913
    @diegofantoni913 Před 3 měsíci

    Hola amigo que valor en ohmios tienen esos sendores ? En k

  • @AIVENGO777
    @AIVENGO777 Před 5 měsíci

    Чем производили поиск датчика?

    • @k-nemo
      @k-nemo  Před 5 měsíci

      Сорвал изоляцию, датчика не нашел. Я оставил его и поставил новый.

  • @BodyHAsker
    @BodyHAsker Před 10 měsíci

    When i test its read until 19.20 and suddenly didn’t read enything . What’s that mean?

    • @k-nemo
      @k-nemo  Před 10 měsíci +1

      Maybe you had the range measurement set to 20kΩ?

    • @BodyHAsker
      @BodyHAsker Před 10 měsíci

      @@k-nemo Yes, I have done it on 20k and tried the same thing more than once. My problem I don't know how to solve it for more than a year, which is that the refrigerator has a lot of ice so the ventilation holes are clogged and the cooling becomes weak, but the freezer works in good condition.

  • @andr3iu
    @andr3iu Před 6 měsíci

    That was a funny video! Also the fridge is funny.. you have to cut it open to replace a stupid senzor. omg. i'll never buy beko

    • @k-nemo
      @k-nemo  Před 6 měsíci

      I'm afraid it's similar in others.

  • @apismachang406
    @apismachang406 Před 7 měsíci

    Not good brand. Becouse no maintenance access

  • @Gruxxan
    @Gruxxan Před 2 měsíci

    i cannot find a replacement sensor to buy anywhere. any ideas where i can get one(UK)?

    • @k-nemo
      @k-nemo  Před 2 měsíci

      Unfortunately, I don't remember where I bought it. There are many online stores. Write to them, ask them. Maybe you will find help on some forum.

    • @unfocusedjoker4374
      @unfocusedjoker4374 Před měsícem

      E spares. You put in your model number and part you want

  • @user-pk8hj4kh3y
    @user-pk8hj4kh3y Před 8 měsíci

    Музыкант

  • @themodelrailwayrepaircentr297

    Came to see about repair, not to be preached to by political adverts

    • @k-nemo
      @k-nemo  Před 2 lety

      We don't like advertising.
      But it costs money to run a service. It's free to watch.

  • @user-pk8hj4kh3y
    @user-pk8hj4kh3y Před 18 dny

    Кроме музыки больше ничего нет , безпонтовый ролик😂😂😂😂😂😂😂😂😂😂😂😂😂

    • @k-nemo
      @k-nemo  Před 18 dny

      @@user-pk8hj4kh3y Извините, но я не делал версию для слепых.