Sonex Tail Kit Step by Step Build: Part 1

This is part 1 of a video series showing the step by step building demonstration of the Sonex Aircraft's Tail kit (vertical and horizontal stabilizers, rudder and elevator). From tool selection to final riveting - the entire build is documented in this HomebuiltHELP video now brought to CZcams. Each part follows the previous video section in sequential order. This tail kit is essentially the same for both the Sonex and Onex model aircraft kits.
Past TIPS archive: homebuilthelp.c...

[@ikay2102]

Thank you Jon, you inspired me on alot of projects that i been planning to start but didnt have the right moment. Now 2 are in process being build, thanks .
Any info is blessing.

[@Superdummy803]

Great video. Keep up the good work.

[@Michael-xo8lw]

Excellent video!

[@perrycorn2789]

I found by drilling a small hole on the trailing edge and leading edge below the line and on the bends stops the distortion of Han just file to the line

[@farhanfouadacca]

Good learning video.

[@gvrose1]

well documented! Thank you!!

[@5xls]

I wish Sonex had a build manual like other kits instead of just blueprints. I'm sure it's just me, but I found them much harder to follow than a 3 ring binder of step-by-step directions would be (Zenith, RV, Kitfox, etc.). And I'm an A&P who got straight A's in blueprint reading/drawing! I built the Sonex tail kit, then sold it. What are your thoughts Jon?

[@alankachalsky6085]

Does anyone know the name of the clamp shown at 14:33 of 'Sonex Tail Kit Step by Step Build: Part 1 and where I can get this clamp?

[@amtpdb1]

How do you debur the inside of a hole tight against the side of a tube that you have no access to such as a gyro 2" square tube with a 1/4" hole? This is what you deal with while building a gyroplane.

[@5xls]

I use this type of tool for that. You can carefully debur the inside of a hole from the outside. www.aircraftspruce.com/catalog/topages/deburringtool.php?clickkey=7152

[@Cretan-un6ul]

make ch 701 dvd free.