Will It Run? Farmall 300

Sdílet
Vložit
  • čas přidán 23. 08. 2024
  • We've brought home another Farmall, this time a 300 and we try to get it running. Watch to see if we were successful! Do you think it will run?

Komentáře • 11

  • @ritawilliamson1394
    @ritawilliamson1394 Před 12 dny

    It’s going to be harvest season by the time he gets it running maybe even snow plowing

  • @williammatzek4660
    @williammatzek4660 Před měsícem +1

    John Deere and International both used Swartz wide front ends in the fifties. My John Deere 70 has a Swartz wide front axle.

  • @thomasr.miller5553
    @thomasr.miller5553 Před měsícem +1

    Geeepers 😳I could have had that thing running in the time this video took. Check compression and for sticky valves. run new switch and wire to the distributor . new point and non resistor coil. rebuild the carb. NEW fuel line .TAKE THE WHOLE CARB OFF AND SOAK IT IN EVAPORUST ! 😁 thanks

  • @williammatzek4660
    @williammatzek4660 Před měsícem +1

    Anytime you pull a tractor always hook on to the frame!

  • @larryklostermann5779
    @larryklostermann5779 Před měsícem +1

    Nice video

    • @WildFarmLife
      @WildFarmLife  Před měsícem

      @@larryklostermann5779 thanks for watching!

  • @user-wb6tw6uz5k
    @user-wb6tw6uz5k Před měsícem +1

    you willl eventually get it to run if you can ever get the jung out of the fuel system.

  • @ritawilliamson1394
    @ritawilliamson1394 Před 12 dny

    I don’t think this guy knows what he’s doing

  • @PaulHigginbothamSr
    @PaulHigginbothamSr Před měsícem

    This guy needs to bypass the starting solenoid. He needs to hook that battery directly to the starter. The starting solenoid does nothing. That is if the battery is good. I haven't seen him even meter the battery to see what the voltage is. So we don't even know the state of the battery. How is it he doesn't even know the plier or screw driver trick to try to jump the starter. I am quickly loosing faith in this farmer.

    • @WildFarmLife
      @WildFarmLife  Před měsícem

      I actually load tested battery 400 amps with a carbon pile load tester. Tested solenoid and it’s functioning properly. Starter winding has a bad spot in it. Pulled starter out turned it a little and it works until it hits the bad spot. Edited some of that boring stuff from the video