Installing Hollow Cylinder Head Alignment Dowels

In this video I show you how I install Cylinder Head Alignment dowels without damaging them. If this video helps you out, and you want to see more subscribe.
Disclaimer:
Due to factors beyond the control of Grim Repair, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Grim Repair assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Grim Repair recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Grim Repair, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Grim Repair.

[@Madmax-yt1cp]

Thanks for the video

[@GrimRepair]

You're welcome, let me know if you need anything.

[@tman3944]

good video! however can you use your old head bolts to drive the dowel pin?

[@GrimRepair]

Thanks. Yes, if you have enough threads sticking out, a nut, and a washer.

[@tman3944]

@@GrimRepair I just discovered you need a lot of slightly bigger nuts and washers