Velikost videa: 1280 X 720853 X 480640 X 360
Zobrazit ovladače přehrávání
Automatické přehrávání
Přehrát
tune is ripe. you got it right at that sweet spot. hear that 4 stroking! love it! is is not ported? cause man you got me wondering if it was
Anyone try the Oregon Speedcut Nano yet? The 3/8LP is okay but I'd think 0.325 / 0.043 should be better. That must be what Husky is running on their cordless saw? X-cut?
Put a panther 1/4 pitch kit on it with bar length of choice and do a timing advance and it rips
Sugihara 8” is lethal
Going to say I’m going to need your carb settings and where you got the pipe.
Pipe is 55 bucks direct from Egan. It's just a flange and a small pipe....fairly loud. I did have to adjust my carb.
Did you port the machine..?
Yh
Never pull out
That seems kinda slow no?
Look how small it is
Few more modifications in the future should help speed it up a bit.
tune is ripe. you got it right at that sweet spot. hear that 4 stroking! love it! is is not ported? cause man you got me wondering if it was
Anyone try the Oregon Speedcut Nano yet? The 3/8LP is okay but I'd think 0.325 / 0.043 should be better. That must be what Husky is running on their cordless saw? X-cut?
Put a panther 1/4 pitch kit on it with bar length of choice and do a timing advance and it rips
Sugihara 8” is lethal
Going to say I’m going to need your carb settings and where you got the pipe.
Pipe is 55 bucks direct from Egan. It's just a flange and a small pipe....fairly loud. I did have to adjust my carb.
Did you port the machine..?
Yh
Never pull out
That seems kinda slow no?
Look how small it is
Few more modifications in the future should help speed it up a bit.