Mk5 Ignition lock housing replacement.

Sdílet
Vložit
  • čas přidán 19. 09. 2022
  • How to replace the commonly failed ignition lock housing in your mk5 vw and Audi vehicle.
  • Auta a dopravní prostředky

Komentáře • 29

  • @poloaguilar4744
    @poloaguilar4744 Před měsícem

    thank you for the video i just cant believe you took that off without removing the steering wheel

  • @user-fg2dr8qp5s
    @user-fg2dr8qp5s Před 9 měsíci +2

    Legend I did take away that one tip about the centre clip on the sensor box. You're doing the Lord's work sir

  • @rorieebert
    @rorieebert Před 4 měsíci

    Thank you so much for your very calm and logical description with steady video of how to remove the steering column module. It made this portion of changing the barrel much simpler.

  • @joshc4136
    @joshc4136 Před rokem +3

    Life saver! That middle clip on the box under the wheel had me stumped! I was able to use a small Allen wrench to get it.

    • @pinrod1
      @pinrod1 Před 6 měsíci

      Me too man, I felt like something was going to break, so I went searching

  • @sterlingsherrod1907
    @sterlingsherrod1907 Před 8 měsíci

    Do it yourselfers' are GOD sent. Thanks chief. Yo VW - screw your corporation prices for simple 'hobby' labor work.

  • @annelodobasic6083
    @annelodobasic6083 Před 9 měsíci

    Good job love your video!!!!

  • @acestevens4323
    @acestevens4323 Před 2 měsíci

    Great vid mate Thanks

  • @DillionJones21
    @DillionJones21 Před rokem

    What type of screw did you use from the micobit set you purchased from Walmart? Also can you please share the microbit set information? I’m attempting to remove the same screw & need to purchase a set with the screwdriver to remove it.

    • @ckrummy13
      @ckrummy13  Před rokem

      Hyper Tough 44 Piece Precision Multi-type Screwdriver Bits Set TS99913A
      It’s a torques, not sure what size but that should be easy enough to figure out. Good luck

    • @bjthebrain968
      @bjthebrain968 Před rokem

      ​@@ckrummy13 just removed em on my BIL's 2010 Jetta earlier today. Were T25 for me.

    • @motodork
      @motodork Před 10 měsíci

      @@bjthebrain968that tiny one is not a T25. I really need to know what size it is.

    • @Yz4Life
      @Yz4Life Před 6 měsíci

      @@motodorkI’m sure you’ve got it by now, but for anyone in the future - that very tiny bolt at the front of the steering sensor box is a T9

  • @SupervisorMartinez
    @SupervisorMartinez Před 11 měsíci +1

    Approximately how many wire did you unplug from the cylinder it self

    • @ckrummy13
      @ckrummy13  Před 11 měsíci +2

      I believe it’s either 1 or 2. 1 is on the main body and the other is for the key reader but that might be a different part.

    • @SupervisorMartinez
      @SupervisorMartinez Před 11 měsíci +1

      @@ckrummy13 Update… Job Complete And Successful .
      Thanks For The Follow Through On The Procedure ….

  • @rillamagic75
    @rillamagic75 Před 8 měsíci

    What should I do if I replaced my ignition cylinder it worked at first but then now my key is not turning again

    • @ckrummy13
      @ckrummy13  Před 8 měsíci

      Make sure it’s not stuck on the steering lock. After that, maybe a warranty issue?

  • @angelramirez-mc9jr
    @angelramirez-mc9jr Před 8 měsíci

    Does anyone know the part number?

  • @enrestmoore357
    @enrestmoore357 Před 8 měsíci

    Did this double-checked everything all my wires are connected everything is hooked up correctly replace the battery in my key I don't have the keyless entry I have a normal key just like in the video and when I start the car it dies it says no key detected

    • @ckrummy13
      @ckrummy13  Před 8 měsíci

      Any chance you damaged the receiver while you had it apart?

    • @enrestmoore357
      @enrestmoore357 Před 8 měsíci

      @@ckrummy13 I'm not sure how to tell if I had

    • @ckrummy13
      @ckrummy13  Před 8 měsíci

      @@enrestmoore357 not sure if anything stands out to you, I would assume it’s a bad connection somewhere, there are a bunch of little ones. Have you tried it again a few hours later. I had an issue with the mobilizer 1 time, waited till the next day and it fired right up and hasn’t been an issue since

  • @EastDallasKicks
    @EastDallasKicks Před 7 měsíci

    Mine failed at the gas station like 2 months ago very annoying

  • @elflaco9210
    @elflaco9210 Před 3 měsíci +1

    I fixed it, but now my horn doesn’t work anymore.

    • @ckrummy13
      @ckrummy13  Před 3 měsíci +1

      Hmm not sure how that’s related. I would recheck your electrical connections. It would have to be something unhooked.

    • @elflaco9210
      @elflaco9210 Před 2 měsíci +2

      ⁠@@ckrummy13mb yea I didn’t have it all properly connected 😔

  • @TougeSolo
    @TougeSolo Před rokem

    Sir your door thinks its a jar.

  • @rudolphpotter4167
    @rudolphpotter4167 Před rokem +1

    😑 𝓟Ř𝔬𝓂𝔬𝐒ϻ