Video není dostupné.
Omlouváme se.
IQ4 NS: Setting Up Using IQ Installer Interface App
Vložit
- čas přidán 6. 08. 2024
- In this video, Dylan from Alarm Grid shows you how to access the Qolsys IQ4 NS using the Qolsys IQ Installer Interface App. The IQ4 NS is similar to an IQ4 Hub, but with no screen. So, programming must be accomplished using either the Installer Interface App or the Alarm.com dealer portal.
00:00 - Introduction
00:53 - Powering On
02:25 - Connecting the App
04:21 - Change Access Code
04:50 - Installation Wizard & System Tests
07:39 - Add Sensor
09:02 - Configure Sensor
11:05 - Add User Code
13:56 - Test Sensor
15:40 - Misc. Installer App Options
16:40 - Outro
You need to download the Qolsys IQ Installer Interface App from the iOS App Store or Android Google Play Store before you begin. When you launch the app, you'll have to agree to the EULA Terms and Conditions. Once you do, when you press Start you'll be prompted to either manually enter the panel Serial Number and IMEI number, or to use your device's camera and scan the QR code located on the back of the panel. Once the information has been obtained by the app, you'll be provided with instructions through the app.
Press the power button on the panel twice rapidly to put the panel into pairing mode with the app. Follow the app's onscreen instructions to pair with the panel and to connect it to WIFI. Once that's done, the app will go through a system test of the IQ4 NS and the results of that test will be displayed in the app. To skip ahead, you can press the right arrow at the top right of the app screen.
The first programming option after the system tests have been completed is zone programming. Follow the on-screen prompts provided by the app to complete the addition of zones. When a sensor has been learned in, but the configuration screen has not yet been accessed, that zone will show up as "not-configured". Be sure to go through each zone and choose a proper response type and zone name, along with any other customization that may be required for that sensor. Always be sure to press "Save" when done. When all zones have been configured, press the "Stop Autolearn" button, confirm you want to stop, and then use the right arrow at the top right to move to the next option.
Programming Z-Wave devices is the next option. We skip that in this video because we will have a separate video specifically for programming Z-Wave. We also skip the next programming section, which is the addition of IQ Remote keypads. The next programming option is user codes, which Dylan walks you through. It is important to note that the IQ4 NS will not allow you to have duplicate user codes, you can see what happens if you try to do so during Dylan's walk-through.
Dylan shows you through a few miscellaneous screens that you'll see when using the Installer Interface App, then the video wraps up.
www.alarmgrid.com/faq/how-do-...
alrm.gd/get-monitored
I work for a security company and installed this for the first time today. Ive been doing security for over 6 years. I hate this panel lol wifi wouldnt connect and it was a PAIN to perform a cell test
I hope you found the video helpful. Thanks for watching.