Advice to put this piece back perfectly: When roughly in position, get your fingers though the gaps and poke the 3 plastic nubs in an upwards position (they're very loose and will fall back down with a slight knock so be gentle) once theyre facing upwards, get out the car and look through the window though the gap to ensure all 3 of them are directly infront of the holes they go in to, once they're in position, give the piece a firm tap with the bottom of your fist all along the length of it, screw it in and you're done. I'd recommend having the negative battery terminal disconnected for 15 minutes before hammer fisting this though if you have air bags.
heh a good workout :) who needs the gym. Hardest thing about doing these type of videos is placement of camera, often so awkward to show and do. especially with one hand. Your viewers and subs appricate it thank you. I do like the way you present your videos, not over long and show as much as you can in basic steps too. Keep it up.
Thank you, this worked for my 06 new beetle convertible. Didn’t have the speaker connected, or anything else so was even easier. Also didn’t have anything to get stuck on while pulling it out; sorry for your struggle on this model. It doesn’t have the A-pillar airbag similar to this model car.
I couldn't manage to remove the two top clamps. They existed the plastic retainer by plastic/elastic deformation. I plan to replace both top clamps just to make sure i still have the CAIB working
These are safety clips, you should slide them off the trim ( that's why slots in pillar are longer ). They need to be replaced with new ones - yours are now broken and should the airbag be deplyed entire pillar trim can breake loose at great speed.
Two of them are ment to keep the trim in place after curtain airbag deploys, the lower one(3th) should Disengage to permit rupture /or disangagement so airbag can protect driver and rear passanger
The airbag deployment is complex and being simulated manny times by specialist, trim geometry updated even before it makes to production. Just as info to all tech people removing interiortrims out there😊
Advice to put this piece back perfectly:
When roughly in position, get your fingers though the gaps and poke the 3 plastic nubs in an upwards position (they're very loose and will fall back down with a slight knock so be gentle) once theyre facing upwards, get out the car and look through the window though the gap to ensure all 3 of them are directly infront of the holes they go in to, once they're in position, give the piece a firm tap with the bottom of your fist all along the length of it, screw it in and you're done.
I'd recommend having the negative battery terminal disconnected for 15 minutes before hammer fisting this though if you have air bags.
Thank you I was trying the same on arteon to install a dash cam but was afraid to pull too hard. Now I know what’s under it!
Thanks, exactly what I was looking for. Bless you.
Thanks for your efforts!
Thanks. I need this video.
A je to! thank you for this video.
heh a good workout :) who needs the gym. Hardest thing about doing these type of videos is placement of camera, often so awkward to show and do. especially with one hand. Your viewers and subs appricate it thank you. I do like the way you present your videos, not over long and show as much as you can in basic steps too. Keep it up.
Thank you, this worked for my 06 new beetle convertible. Didn’t have the speaker connected, or anything else so was even easier. Also didn’t have anything to get stuck on while pulling it out; sorry for your struggle on this model.
It doesn’t have the A-pillar airbag similar to this model car.
Ahoj, náhodou video ako čistiť odtokove kanaliky na golf 7 už je niekde na YTA kanaly alebo bude?
Very useful!
I couldn't manage to remove the two top clamps. They existed the plastic retainer by plastic/elastic deformation. I plan to replace both top clamps just to make sure i still have the CAIB working
Thanks for the video, gives you an idea of movement, flexbility of panel so it gave me courage to pull hard
Ted jsem to delal to stejny. Ale plasty jsou misty pro airbag ohebny a zbela plast po ohnuti, tak se kupuji nove plasty
Tuto na golfe je ten plast niecim potažen. Tak to nezbelalo. Ale skoro sa dolamali tie drzaky tych klipov plechovych
i will try thx
These are safety clips, you should slide them off the trim ( that's why slots in pillar are longer ). They need to be replaced with new ones - yours are now broken and should the airbag be deplyed entire pillar trim can breake loose at great speed.
Two of them are ment to keep the trim in place after curtain airbag deploys, the lower one(3th) should
Disengage to permit rupture /or disangagement so airbag can protect driver and rear passanger
The airbag deployment is complex and being simulated manny times by specialist, trim geometry updated even before it makes to production. Just as info to all tech people removing interiortrims out there😊
Caw potreboval bisom tvoju pomoc
And yet the damn thing still manages to rattle over the slightest imperfection in the tarmac...
Not something you want to do more than once, that looks difficult.
Boa.
piknie dikuju
Good. But not easy at all
Berbat çalışma