2023 Honda CRF250 with QS motor and Votol EM260S controller Install. Today the controller

Here is the installed controller. I made the plates to mount the controller. Welded them in, Then mounted the mudflap solidly to the controller mounts since the airbox is gone. Day 2

[@elekid330]

these long videos are kinda exhausting as it is but when theres that together with pointing out the obvious and kinda minimum energy no exceitment it gets kinda painful

[@longboarderebright]

what are the dimesnions of that usps box you have in the frame? i am looking at getting an older crf250 frame because that have the large opening vs the yamaha and drz

[@maeso34]

Hi, Donald. Is it the pump for cooling the controller’s heat sink? How is it gonna work? I don’t remember you did that in your Yamahas. Thanks in advance.

[@dcoxryton]

I didn't put it on my YZ250F. I never had enough amps. My battery would only give me 380Amps. Antonio Rudello saw the heat buildup on his. This bike is for a young upcoming kid that rides pretty hard. Wait until you see the mods we are doing to the battery to keep the heat down on this Honda. I am putting a new battery in my YZ right now also, 20S12P Molicel P42A. I will have to cool my controller too.

[@elekid330]

youve owned all those bikes there and you mean to tell me you never worked on any of them never dismantled one stripped rebuild anything ??

[@elekid330]

yea dude ummm idk but i dont think a 20kw setup would be so inexpensive my 72v 3kw can do 65 on fullpower