Blend door USA Dodge Ram blend door replacement
Vložit
- čas přidán 27. 08. 2024
- In this video I remove the heater box and replace the blend doors with aluminum blend door USA doors.
2003 Dodge Ram dash removal and dash top replacement • 2003 Dodge Ram dash re...
I attribute my successes to god and give him the glory.
“Jesus said to them, “I am the bread of life; whoever comes to me shall not hunger, and whoever believes in me shall never thirst. But I said to you that you have seen me and yet do not believe. All that the Father gives me will come to me, and whoever comes to me I will never cast out. For I have come down from heaven, not to do my own will but the will of him who sent me. And this is the will of him who sent me, that I should lose nothing of all that he has given me, but raise it up on the last day. For this is the will of my Father, that everyone who looks on the Son and believes in him should have eternal life, and I will raise him up on the last day.””
John 6:35-40 ESV
Thanks, Jason, another interesting journey into the mysteries of the modern motor vehicle! 😊
Thank you. By the time I’m done I’m going to know where every nut and bolt is.
Hey, how is this project going? We need an update 😇
I just started working on it again recently. I have some video to edit but not much progress. I’ve been doing a lot of little things like broken connectors, bleeding the brakes and such. It’s hard to get much done with it in the tent garage, but to heavy to push in and out. I’m going to push to get the fuel system and bed on so I can get it moving under its own power again.
nice video, but before mounting I would have disinfected the air ducts imho
I know what you mean. I did clean out the inside of the box that I didn’t record. I don’t recall if I used the microban on it but the box I used was just dusty. It didn’t have mildew on it like the other one I had. I did have to use a piece of the other box and it was the big piece that was all wet. That I did disinfect.
That wasn't too bad in this situation, like a big erector set. Was the heater core aftermarket? if you said I missed it.
I got a factory heater core. It was pretty straightforward just a million screws. Lucky they are all the same size. Could you imagine needing to keep track of where they go.
@@JasonTheMunicipalMechanic No I can't
What site did you use to order the aluminum parts
www.blenddoorusa.com
I wish the OEMS would get away from using foam of any type anywhere. It just doesn't last or hold up.
I agree. It was just coming right off by touching it. I’m hoping the stuff I got from the store will handle the heat
Sounds good but what would they use in its place.
WWW sent me.
His recommendation was a big surprise. I still remember when I found out. I was showing a friend the CZcams studio app and my subscriber count was at the time up about 1500 people. I didn’t know why, then I saw everyone saying Wes sent them in the comments so I had to investigate. It’s surprising being noticed by a large Channel like Wes’s, he’s a nice guy and I really appreciate him recommending my channel. It took me about a year and a half to get to 1k subscribers and it went to about 3400 in two days thanks to Wes. Thank you for coming over and giving me a chance, I appreciate it too.
You should capitalize the g in God.
Your right, I’ll have to start doing that.