PCV Valve Inspect And Replace On A 2010 Hyundai Accent....
Vložit
- čas přidán 25. 08. 2024
- PCV Valve Inspect And Replace On A 2010 Hyundai Accent.
I Remove The PCV Valve, Check It For Proper Operation And Install A New One.... Simple And Quick Project For The DIY'er In All Of Us....
You May Be Able To Clean And Reuse It, But Y'all Know Me - If I Go Through The Trouble Of Removing It - I'm Just Going To Replace It......
---------------------------------------------------------------------------------------------------
Torque Specs:
I've Painstakingly Tried To Ensure These Are Accurate, But...? You May Wanna Double Check These.... I Set My Torque Wrenches To The Middle Of Each Range....
Also Note - Newton Meters Are On Top First Because The 1/4" Drive Torque Wrench Was Easier To Use In Newton Meters.....
PCV Valve...
Torque:
(7.8 ~ 11.8 N.m.)
5.8 ~ 8.7 lb-ft ...
Engine Cover Bolts..
Torque:
(3.9 ~ 5.9 N.m.)
2.9 ~ 4.3 lb-ft ...
---------------------------------------------------------------------------------------------------
This Video Is For Your Enjoyment Only....
I'm Not A Mechanic And Not Responsible For Anything You Do To Your Own Car....
Thanks For Watching ! !
/ yardsigns.allen
/ yardsignsinc
#YardSigns #AllenLearnsToBudget
Thank you so much for this. A very easy job that took less than 30 minutes. This is brilliant preventive maintenance.
You're Welcome...
Good job !
Thank you.. not enough words..
Muchas gracias por el video amigo
Thank you so much indeed. I was looking on net about what you did. Pls. Be sure that yours is the best. Be well.
You're Welcome & Thank You To......
do you know where is located mass air flow sensor?
Thank you sr much grateful for the information!!!
You're Very Welcome....
great
thanks for show location were the valve was
Oh - You're Very Welcome....!
Hey i have a Hyundai getz 1.4 gsi and my coolant level went to low within 3 months or less.. i have green gunk inside my oil cap... please advise me what should i do?
I'm Not A Mechanic, I'm Just Learning To Fix My Own Car....
Head gasket has blown, change it, full oil and coolant drain and refill after and let your car warm up every time your use it after instead of going on it right away after starting it
Dang every two years? Ik for a fact mine hasn’t had it done ever and it’s a 2007 with 190k miles. And I’ve been getting horrible mpg as well. Replacing this today lol
Any positive result?
I would have used a ring
What are symptoms ?!
👍
I just bought a 2011 accent the top engine cover was off I don't have the bolts do u no the size of bolts
10 mm
I replaced it but I'm still having issues
What issues?
It’s hard to find “how to’s” about this vehicle close to the 2011 model. I bought a vehicle from a dealership. They labeled it “as is”. This is the first time I bought a car from a dealership and it was shady with them. Any how I like the 2011 Accent (used), and bought it. Anyway, I found grit under the oil cap. When I looked inside, as much as I can, into the valve cover, it was grit burnt and caked along the sides. It looks like someone pour sand through the oil cap.
Is it possible to just clean cover when removed?
Should Be - But I'd Be More Concerned About Something Being Stopped Up.... Did It Get Repossessed Before You Bought It...?
is this accent crdi diesel car?
Gasoline - Not Diesel....
hyundai crdi diesel has a egu?
How many miles did ur car have and was ur car burning oil? Because my accent is burning oil and may b my car will burn less or stop burning period
Mine Had About 153,000 Miles On It At The Time I Think.... It Does Burn Some Oil.... I Haven't Noticed A Lot Of Difference In How Much Oil It Burns, But It Does Appear To Burn A Little Less Oil But Hasn't Stopped....
My vehicle has 130k and burns quite a bit of oil I will replace the pvc valve this weekend to see if it helps but I heard it could also be the piston rings have you tried replacing those?
@@Superjuice17 did you ever find out what was burning your oil because mine is doing it with the same amount of mileage
iam finding milky white dots inside oil cap but not in dipstick..no smoke.. radiator water level is normal..no leak..pls tell me a solution for this problem..
Oh, I Don't Know.... I'm Not A Mechanic,..... Like I Say In The Videos - I'm Just Fixing My Own Car.....
+YardSigns ok👍
It could just be condensation on the oil cap. If you only do short trips with the car, try taking it out for a longer drive on the highway (with the engine at full operating temperature). If it goes away after that there is nothing to worry about
+TacoGuy135 yes sir I tried its not there during long trips. thankyou..
@@armrub4033 glad to hear it's ok! :)
even if it is uncorked and evacuate the dirt, it is quickly clogged after, better to change completely after 40 000 Km - 50 000 Km, 8$ is nothing
Yeah - I've Noticed That Wasn't As Clear As I Would've Liked It To Have Been.... I Did Replace It... I Don't See The Point In Cleaning It Though...
I'm Doing Another One Here Soon - Hopefully It Will Be Clearer On That....
Yeah, At $ 8.00 Or So - It's Cheap Enough To Replace It Once A Year Or More....
I don't know about you but I wouldn't poke anything that might damage the internals.
LOL, I'll Keep That In Mind...... Ya Know, I Thought The Only Things In There Was A Spring And Plunger..... Now You Have Me Curious Enough - I May Make A Video Cutting One Open To See What Is Actually In It.....
Yep, springs and valves do get damaged, ya know. Hyuk hyuk. stupid fuck@@YardSigns
Eye Sea.... So. . . How Would You Recommend Checking It Without Poking Anything In It....?..?
I would save myself the time and frustrationI by replacing them since they're a dime a dozen.
While I Agree With You On That - I'm A Little Confused By Your Channel Name Having "Frugal" In It.....
I THOUGHT I Had Said It's Cheap Enough And Better To Just Replace It In The Video - After All, If I'm Going Through The Trouble Of Removing It - I'm Not Wasting Time Cleaning It - I'm Just Going To Install A New One....
(So I Went Back And Re-Watched The Video) - But No, I Didn't Actually Say I'm Just Going To Replace It..... I Only Mention The $8.00 - $8.50 Cost For The New One I Put On..... (I Went Back And Looked On Amazon - I Paid $8.98 For It On January 7th 2018....) I Did Show The New One Though..... That Wasn't As Clear As I Would Like It To Have Been....
Since I Can't Correct & Re-Upload That Video - I Ordered Another PCV Valve (It's Been Over A Year..)... I'm Thinking About Making An Updated (Hopefully Better) Video...
I Still May Cut One Open In A Video To See The Internals....
I Started A Frugality, Budgeting Channel A Few Months Ago - I May Clean One Up For That Channel To See If That Would Work For Someone Who Doesn't Have The $8.50 - $9.00 Or So To Buy A New One Every Year Or Two....IDK...
Muchas gracias por el video amigo