Re-Repairing a Jeep ECU: Because Once Wasn't Enough
Vložit
- čas přidán 6. 09. 2024
- If you're in need of service or assistance:
-ECU Repair Services: keyworks.us
-DIY/Pro Resources: autoelectronic...
You can also support our channel by using our affiliate links below (or used in our comment replies), where we may receive compensation for your purchases:
-eBay : keyworks.us/ln...
-Amazon : keyworks.us/ln...
-AliExpress : keyworks.us/ln...
If you'd like to make a direct contribution, you can do so via:
-Cash App: cash.app/$ecur...
-PayPal: paypal.me/keyw...
Your support means a lot to us, Thanks for watching!
Thanks for sharing.
i sugest you buy solder paste 183centigrade degrees and better flux also a jbc type tip then you do a cleaner job
Pretty happy with my metcal so no jbc for me. Ive used solder paste on these in the past but don't care for it tbh.
Wow. Your so meticulous! I have trouble soldering these. What I do is heat up the PC board first then the chip when putting it on. The aluminum backing acts as a high heat sink. I've burned several of these chips by heating the chip with the board. I'll think to check for shorts too next time.
These ecu's can be a pain with follow ups if your not careful. I used to put it on a preheater and use hot air but now prefer 2 hot air guns instead.
Hello brother, how can I contact you? I need help. I lost one of the resistors and I don't know what its number was
there is contact info in my profile
👊👍
Did you use two heat guns to install the chip?
Yea, I use two for these