Faulty Washer Control Board Replacement

In this video I show how to access the control board on your Whirlpool Caprio model washer. A faulty control board is a very common issue with these and similar models. Be sure to watch part 2 where I show how to potentially fix a faulty control board for less than 2 bucks!
Part 2 with washer repair: • 2 Dollar Electric Wash...
Contact: [e-mail]

[@douglaswright1892]

This video was informative.

[@javiturk4636]

I believe using a putty knife under each side of the front panel housing, the unit pops back and out. Then it is easier to undo everything.

[@Bdub-dub]

I replaced the control board 😢the washer didn't turn on nor light up

[@victorsoriano1868]

Where did you get the control board?

[@WeakestofWeeks]

I didn't buy another control board, I fixed my faulty one: czcams.com/video/ZmCYXt7ajpc/video.html

[@elmbaker1683]

Why did you remove the cold/hot water lines from the wall and not just the machine?

[@WeakestofWeeks]

If I remember correctly my thought was to initially leave them attached to washer and drop the lines in a bucket to drain. Since they connect directly into the wall shut off not much of any residual water would be coming from that end. I knew the lines would have water in them but I wasn't sure how much water the actual washer would still have. Leaving them hooked up to the washer and dropping them in a bucket ensured most water from the lines and washer drained making less of a mess.