My 2.2jts have very high petrol consumption. Intake valves cleaned new lambdas, decat... i also have some heat getting into the cab somehow, anyone with similar issues?
Hi mate! I have a Brera with this engine, and 160.000km. I think i have your same problem... It burns around 3l oil in 10k km. When does is started yours??
@@tonyshel7672 Mine is burning 230 ml per 1.000 km. Not sure if that is excessive oil consumption for this engine or not. The manual says up to 400 g per 1.000 km is normal, but that is just fake claim. I have replaced the PCV membrane 6.500 km ago. And cleaned the PCV system, including the hoses and the valve under the intake manifold (when I was doing the intake valve cleaning). Could be the valve stem seals, or the (a bit) stuck (or worn) piston rings. I have bought the car with 173.350 km (real), and now it has 180.300 km. What would you do?
@@danieloide787b Dude... Just put it in 6th gear, lift one side of the front of the car and turn the front wheel forward. It will rotate the crankshaft...
Nice tool for this job.
Great job done 👍
What is the name of the tool you are using?
My 2.2jts have very high petrol consumption. Intake valves cleaned new lambdas, decat... i also have some heat getting into the cab somehow, anyone with similar issues?
hi, what tool is that?
Hi mate! I have a Brera with this engine, and 160.000km. I think i have your same problem... It burns around 3l oil in 10k km. When does is started yours??
My problem appeared unexpectedly when I ran about 215 thousand km. The engine ate about 1 liter of oil per 1500 km.
@@tonyshel7672 Does it burn any oil after the fix? I am planning to buy Brera with this engine soon.
@@DashCamSerbia after fix there is a small oil consumption
@@tonyshel7672 Thanks.
@@tonyshel7672 Mine is burning 230 ml per 1.000 km. Not sure if that is excessive oil consumption for this engine or not. The manual says up to 400 g per 1.000 km is normal, but that is just fake claim. I have replaced the PCV membrane 6.500 km ago. And cleaned the PCV system, including the hoses and the valve under the intake manifold (when I was doing the intake valve cleaning). Could be the valve stem seals, or the (a bit) stuck (or worn) piston rings. I have bought the car with 173.350 km (real), and now it has 180.300 km. What would you do?
Hi! Nice wheels! Name pls? Thx!
Hi! Inforged ifg 35 r19
How do you do for don't fall the valves??
kazhdym tsilindrom
I lifted the piston to top dead center with the crankshaft and it supported the valve from below. And so on for each cylinder.
@@tonyshel7672 And how do you conserved the timing when you lifted each piston mate??
@@danieloide787b Dude... Just put it in 6th gear, lift one side of the front of the car and turn the front wheel forward. It will rotate the crankshaft...