How to Install and Hand Cut Paint Protection Film on Headlights
Vložit
- čas přidán 28. 04. 2021
- In this Video I will be installing SunTek Ultra PPF to this 2017 Audi A4 Headlights. I will be walking you through all the steps and showing you the full install. Thanks for watching! If you need a pre-cut Paint Protection Fil check out our website. Link Below.
m2mdetail.com/ - Auta a dopravní prostředky
That was fast. You can always spot a master. Made it look easy
Like that you made this using hand cut PPF. Helps us more DIY oriented people who don't have a laser cutter.
I get more hand cut videos out for you guys 👍
Really good and to the point. T O T H E P O I N T - so good. Excellent explanation of using bulk and not precut. My concern is unusual shapes like headlights. I do wish I understood a little more how to use the heat gun, I have one but am afraid to shrink the PPF. Otherwise thanks and a very good video.
Thank you for the video. I am trying to do this on my C 63S. Problem is the headlights are very round and I get a lot of fingers. What’s the best way to remove the fingers.
Thanks for the video! I was just searching your page for this series of Audi A4 just the other day. I have a couple questions.
1) how much would the kit cost for me to do this on my own?
2) how do you prepare the headlamp for the application? I bought my 2018 A4 used and the headlamp has very tiny chips in it already. Nothing major just looks like typical wear and tear. No oxidation yet, just very small chips. How would I prepare the plastic lens for the PPF to make it as clear as possible. Thank you!
Hey, thanks for watching.
1) cost would $40
2) If the headlights are in pretty good shape I would just buff them out with a compound, polish and then remove any waxes or oil with a paint prep. After that install the PPF. If your headlights need more attention sand them down as you would for a headlight restoration.
What brand of blade is it. And solution. Only hot water ?
😎 Respekt 😎
whats you use in green spray ?
is better with or without water?
What type of blade is that? Thanks.
What type and brand of spray bottles are you're using? For the hot water is it a special insulated bottle?
I use IK bottle
What is your prep method for new headlights?
I would wipe them down really good and do one pass with a AIO compound. Then use a paint prep to remove any waxes and oils.
Hi Mark. Do you cut the film on the headlight or over the edge of the headlight?
Typically on the edge
@@m2mdetail781 Thank you Mark!
Where exactly do you make the cut?
Is it in the panel gap or is it just inside the edge of the headlight?
Inside the edge of the headlight. Most headlights if try to wrap over the edge you will spend a lot of time trying to get that to tack down. So pretty much I go up to edge as close as I can.
@@m2mdetail781 brilliant, thanks..
What wrap do you use or do you have your own range?
@@poddyb4085 suntek reaction most of the time or suntek ultra