4 COMMON SIGNS YOUR WHEEL BEARING IS BAD

In this Video, we're going to explore the symptoms of a bad wheel bearing. We will look at 4 most common signs.
Also Check out:
• Popping Noise When Tur...
• 9 Common Noises Your C...
Your support is much appreciated as we put a lot of work into our videos. We hope you found this one helpful. Thanks for your continued support and appreciation for the content. Remember to like, comment and subscribe to the channel with your bell notifications on to never miss out on our future content.
Thank you for Watching!
#SymptomsOfABadWheelBearing #WheelBearingDiagnostics #BadWheelBearing #ReplaceWheelBearing #SignsWheelBearingIsBad

[@Shooting_Stuff]

Hey man I was seeing an old video of yourself where you were fixing body damage on a Chevy Cruze and you told me I would have to cut out the old fender rail and weld in a new one…. I wanted to know before I start welding in a new one do I need to remove my engine or is there a safety protocol I should fallow?

[@fixit3879]

NOT REALLY. If you cut the fender rail with the engine mount, then you have to support the weight of the engine by putting a jack stand or hydraulic jack under the engine. If you are not touching or removing any of the engine mounts, then you don't have to support the engine. But in either case for Chevy Cruze you don't need to remove the engine. Hope this helps. Good Luck!

[@Shooting_Stuff]

@@fixit3879 i just stuck a 4 ton hydraulic spreader bar up underneath and unbent it enough so a new fender could go on. Harbor freight had them on liquidation sale for like 75% off