Thanks man! With help of oscilloscope and your video we figured out that we replaced old chain with new but trashy new cain. Vq40 finally started well!
Bro this makes sense. What doesn’t make sense is if you line up the damper pulley to the mark on the timing covers inspection window and nothing lines up
How do you verify cylinder 1 is at tdc on compression stroke when installing all new timing set after an engine has jumped time? I have all my timing marks lined up on all sprokets. Im just not sure if im on the compression stoke. Or am i just over thinking this and the marks are where i need to be to start all over? Any input would be appreciated
Wished you would have shown lob positions on bank two. My bank 1 tdc frt lobs are up facing one another. I question bank two lobs when marks are lined up????
Can selinoids cause valves to bend? My murano sounded like it jumped time but when timing cover was removed and engine put on TDC( combustion) . Timing was still set right. All markings were alined. valves sound bent when started.
Thanks man! With help of oscilloscope and your video we figured out that we replaced old chain with new but trashy new cain. Vq40 finally started well!
Very good your video
Very very helpful video... thanks alot
Thank you!
great video super helpful👍👍👍👍👍👍
Bro this makes sense. What doesn’t make sense is if you line up the damper pulley to the mark on the timing covers inspection window and nothing lines up
Thanks a lot
Good video. It might have been good to explain setting the engine to top dead center when you do this…..
How do you verify cylinder 1 is at tdc on compression stroke when installing all new timing set after an engine has jumped time? I have all my timing marks lined up on all sprokets. Im just not sure if im on the compression stoke. Or am i just over thinking this and the marks are where i need to be to start all over? Any input would be appreciated
Great video. Doing my right now. Thanks.
Wished you would have shown lob positions on bank two.
My bank 1 tdc frt lobs are up facing one another. I question bank two lobs when marks are lined up????
Can selinoids cause valves to bend?
My murano sounded like it jumped time but when timing cover was removed and engine put on TDC( combustion) . Timing was still set right. All markings were alined. valves sound bent when started.
Is interference engine? My water pump is damaged, now car won’t start, timing is not right, let me know what should do
Well done brother
Thanks to my buddy Gabriel aka big man!
Nissan Pathfinder 2010 engine kicking back fires refuse to start
Let me know more, I may be able to help
Thanks for sharing.
Thanks for watching!
I have some crank sound from my Nissan Frontier pickup 2006. How do I fix it
You have to do a tear down and check your Main and rod bearings!
What are the plactic parts that will cause problems in the timing area.
Plastic guides
Disculpe compañero sabrá usted que calibración llevan las válvulas de ese motor
🔜 0,26-0,34 mm 🔙 0,29 - 0,37 mm
Hello
Togola adama
Le Thermomix le moteur man moteur
Moteur man