Engine must rev at Max or chips clog shute alot. Otherwise good. Got a Mobark self feed now. Chuck and duck good for light scub. We can't burn piles on Long island NY.
wish my wedges would just pop out like that. mine are a nightmare trying to remove and mine dont have the extra bolt hole to remove them like yours. it sucks.
Edge of cutter bar shelf edge dull...must be Sharp or no cut. Not just blades. Self feeds good now. Run at full 3600 rpm or chute clogs up. Clean shute after each job or chips lock in.
two week ago i pick one up for 3300 shipping 635.00 no good blades so you got a great deal p.s. having trouble getting blades off jam bolt is not releasing wag bar
Chipper looks beautiful that was a steal for a thousand bucks even if you had put some work into it everything's there
Love it!! Thanks for the video
Thanks man! I appreciate the post very much! I have one myself.
well went back out did get those blades out after watching you thanks
Engine must rev at Max or chips clog shute alot.
Otherwise good.
Got a Mobark self feed now. Chuck and duck good for light scub. We can't burn piles on Long island NY.
wish my wedges would just pop out like that. mine are a nightmare trying to remove and mine dont have the extra bolt hole to remove them like yours. it sucks.
did you make a video of putting the new ones in and setting the blades let me no thank you jim
👍🙏
Edge of cutter bar shelf edge dull...must be Sharp or no cut.
Not just blades.
Self feeds good now.
Run at full 3600 rpm or chute clogs up.
Clean shute after each job or chips lock in.
Where are the rest of the videos?
Need more like this
Run at 3000 rpm to keep fan lowing hard or chute clogs up. Just used this on job .
Still going Chuck n duck..carefull don't stand behind it man.... seriously
how many revolutions per minute (RPM) does it rotate?
Unit runs great. Need to build self feed conveyor.
Got a video of adjusting the blades?
two week ago i pick one up for 3300 shipping 635.00 no good blades so you got a great deal p.s. having trouble getting blades off jam bolt is not releasing wag bar
Still using it.
My other channels motorhead1 and Mitzvah Golem has other tech
Torch needed to get them bolts out.
Torch time..
Awesome video thanks. I have a Ford 351 in mine what engine was supposed to be in it new?
Probably a inline 300 six cylinder
My new channel is "Mitzvah Golem" this one dead.