VW Polo Fix for all electric windows not working.
Vložit
- čas přidán 12. 09. 2024
- Fix for all electric windows not working. All the fuses are good and motor is good. the remaining thing is the windows control unit circuit board on the drivers side which is intergrated with the motor.
This video will show you how to trouble shoot and change the two components that are faulty. The 10 pin 12v ACT 512 relat and the 100uF 35v capacitor are the culprit. There are links to where more infomation can be found. I hope this will solve your problem because it solve mine.
This fix worked perfectly. I ordered the parts you advised from ebay. The cost was £6.95 for the relay £2.50 for the capacitor. I had a friend do the soldering for £20.00. follow what this guy says and I'm sure it will solve your problem. There is clearly a issue with this specific part. These components seem to be the problem.
Top video great soundtrack, many thanks👌
Why capacitor is bad? I think it's all relay fault, because I don't see any trouble with capacitor, after visual inspection:( what about yours? Capacitor was blowen or cracked?
Thanks for help also Great track one of my favorite trance tracks of all time.
Bloody annoying track. Highly annoying needs to be removed
@@richardharries5825 bore off
Yep. When something stops working on a canbus vehicle bypass the canbus and use a separate relay and fuse, and power from the battery, and an ignition source, ie, whatever broke.
Thanks for the video! Best music too
Your capacitor looked in good condition, did you measure its capacitance before replacing?
This music made me feel like I was in a gay 90s night club
it takes one to know one 😉
When i put new fuse in it works a couple minutes then stops. Both switches dont work Can this be a fix for polo 9n3 passenger winodow
Hi, How did you get the motor out ? I have a b5 Passat. Can't reach the screws the screws without breaking the regulator 😔
Good video
I have a Skoda Fabia TDI from around the same time. I had some battery trouble during lockdown and I have recharged then replaced the battery. I have tried everything to try and reset the windows according to the manual (not working at all), so I am starting to think that it was just coincidence that the windows went at the same time. I suppose unlikely for both motors to go, so the control unit seems more likely.
I still have a soldering iron from a while back, so I could give it a go, nothing to lose. I have heard that relays and capacitors can go. I had a couple of relays go on my central heating circuit board too - fried.
Many thanks for the info in any case.
Before I try the circuit board, I am now thinking it could be the reset procedure using the key and the driver's door lock. If this isn't working then the windows would stay inactivated on my particular model (2008). Some models I believe it is just the convenience close that is deactivated. I have a feeling the window open shut using the key never did work since I have had the car. If this is the way to reset, then it wouldn't work in this case. I will check the connectors and continuity. Obviously there must be a connection between the door lock and the window control unit.
However, it is quite wet and windy today and I can't be bothered going out to do it. Will report back on the outcome for anyone interested.
@@seismic6402 did you figure it out?
Hello, The right window of my 2006 polo car has been working for a short time after removing and installing the battery terminals.then it stays on, if it stays on, if it stays off, it stays off.can you write a comment about the problem
Very informative vid👌🏽. Well I have a different problem: mine (polo vivo front powered windows) shuts off soon as drive speed exceed 60km/h and won't operate until you stop, switch off the ignition and give it a few secs before you start again🤔, and same issue repeats soon as you drive again (over 60km/h😏). What could be wrong?
Please help! 😢
This seems a strange problem but perhaps not so much when you consider electronics can work in weird and wonderful ways. The voltage would be higher when the car is running could offer a possible explanation. Everything being equal of course it shouldn't happen but degradation of parts on the circuit board like the video above suggests could be an explanation. In between working properly and not working at all, there may be an intermittent stage.
As the poster says, if you take off the motors and test both the motors and control units separately and then decide where to go from there. If money isn't an option of course take it to a garage and electronic diagnostics may throw up something useful. You could get both motors and the control unit replaced if you really don't want the headache too.
Dear friend, On my Polo 9n 2007, before all windows did not work only in winter. Now they always do not work. Did you have there too?
First check wires in doors if not, then check buttons as well and then reach motor it can be many problems there
Same car, exactly same problem, looks like the cables are corroding for me. Trying to fix it rn but now it works for a few minutes and then stops
@@stevenvanzijverden7015 may be relay act 512 12v that located in drivers motor block, or BCM is in bad condition. Check for mistakes with odb2
So how you no exactly there is problem.
Please help me my car is not working windows
I have Volkswagen Polo driver side and passenger window is not moving at all power is not going on the Switch Fuse is okay.
Probably the motor is broken. If all the other's are working. You have to pull it out and test it
Hi Gents,
I have a polo n9 2007 series ,
The problem is the passenger window who is not working,
When I disconnect the battery the window works, I close the car after a few minutes I try to open the passenger window and the problem is the same ,
Can help to find an issue,
Note that the window does not work also from the both bottoms
HI I havent encountered this problem. Try to trouble shoot. isolate different components to rule them out. It sounds like a relay problem like mine. because when you disconnect the power the relay resets and when you use the power window the relay gets stuck and stays in that position. Hence works once or twice. Not sure if there are relays in both sides. When you replace the relay replace the capacitor too. Good luck
Would this work on a 3 door gti and can u just replace the whole unit??
Ahmed,
I have the same problem with my Polo 9n1.
Did you founded the solution ?
@@darrenlokster I have the same problem with my Polo, when I disconnect the battery and put it back on again the windows work, but after a few minutes they stop working. I've replaced this motor unit but still the problem persists
U need to resolder the solders After many years will small cracks show up. The right window on my car works only when its hot outside.
What if I find the system?
Hi does anyone have the item numbers for the repair parts on eBay thanks
Capacitor 100uf 35v: the capacity has to be the same, the voltage may have higher (45v or higher)
Act 512 12 v 10 pin google and u get the item. it can't go wrong
Hi if anyone could answer would be great. my windows aren't working n planning on following this video.
Just wanted to check how i would make sure it wasn't a fuse problem?
Car: polo 57 plate
Test it with a multimeter. Fuses and if electricity is coming to the window switch
Реле тут вообще не причем
Легко проверить, если оно рабочее то должно щёлкать.
Why this music?
why not
If you asked, you clearly dont know. Probably to young 😆