International 4700 LP 444E Crank but no start.

Sdílet
Vložit
  • čas přidán 4. 01. 2021
  • International 4700 LP 444e international engine 1995 chassis. crank but no start advice on diagnostics of no start or no crank.

Komentáře • 17

  • @jaliscorojo1
    @jaliscorojo1 Před rokem +2

    Thank you for such good video My truck was seating at my shop over 4 years refusing to give up had few mechanics work on no luck I come across your video BOOM stared first try thank you .
    Note : This videos should be nominated for an award is no JUNK.

  • @terryherrera5252
    @terryherrera5252 Před rokem

    No snow/salt problem in Houston !!!
    But fuses down there rang a bell !!
    Mobile Mechanic had fixed this before !! TWICE !! A truss Carpenter watched Hm the second time ! Said he watched over his back n he changed a fuse !!! $260 !😡😡 - I confronted him n he said his time ???
    You are right ! Very dependable truck !! BAD diesel mileage w/v-8 😩 BuT we have changed the fuse 2 more times !!
    I checked your /OUR rubbing issue !! Found 2-rubbed pretty bad !
    Have alleviated that !!
    Great video !!
    TANKS !

  • @charleschoat5917
    @charleschoat5917 Před rokem

    Thanks a bunch. Will check this. Was about to tear into the fuel system or the brain box. Hopefully this does the trick.

  • @robstuckey
    @robstuckey Před rokem +1

    good video, thanks for sharing

  • @reychingon74
    @reychingon74 Před 2 lety +1

    That's a beautiful truck

  • @KaseyB4000
    @KaseyB4000 Před 2 lety +1

    Thanks for the video, very helpful

  • @kevinmurphy1975
    @kevinmurphy1975 Před rokem +2

    Your video just saved me a whole lot of trouble shooting!!! Thanks for sharing.

  • @bonniej2609
    @bonniej2609 Před 2 lety +1

    Thanks for pointing these out. Question, do you get the "wait to start" light when you try to crank or No?
    I've seen other vids talking about "Fuse 22" for the Heater bowl Element- haven't been able to trace that kne down.(i'm the 6th or 7th owner of this truck- first time its let me down jn 3 years)

    • @oaktree185
      @oaktree185  Před 2 lety

      Yes I still get to wait to start light even with the no crank.

  • @tizzy9591
    @tizzy9591 Před 2 lety

    How did you replace the wires in the back

    • @oaktree185
      @oaktree185  Před 2 lety

      I replaced the bad section of wire by cutting out the affected area and using a 3M at the manufacturer heat shrink connectors there's now multiple manufacturers but at the time 3M was the best on the market. The beauty about the heat shrink is it helps keep water and contaminants out.

  • @maxpower8225
    @maxpower8225 Před 2 lety

    I have the same problem crank but won’t start
    Already replace sensors, hpop, and nothing

    • @oaktree185
      @oaktree185  Před 2 lety

      Have your injector drive module tested. I've had that fail one time in the 14 years I've had the truck. The truck will crank but they'll be no start because there's no command to the injectors.

    • @oaktree185
      @oaktree185  Před 2 lety

      Don't take it to the dealer they'll rip you off on it I found out the hard way the tech that I normally took things to he was on vacation the week that it broke and I didn't have a way to check and find out the diagnostics the dealership got me I did get it fixed but it was expensive and then found out from the tech I normally go to that he would have been able to tell with his equipment but it all worked out