Gen 1 Sonic/Cruze Z04 Turbo Install | Part 2

In part 2, Ryan takes you through the turbo install process on a 1.4 Gen 1 Sonic or Cruze. This install is done on a Cruze, but you can also follow this video for a Sonic. If you have our intake, you can follow the install process here: • How To - ZZP Sonic Col...
Pick up your Z04 here: zzperformance.com/collections...
0:00 Intro
0:20 Motor mount and serpentine belt (Cruze only)
6:20 AC compressor bracket
10:05 AC compressor
11:08 Turbo
16:17 Primary O2 sensor
17:58 Oil feed line
22:17 Top coolant line
23:28 AC connectors and lower bolt
23:48 Lower coolant line
26:20 Oil drain line
27:00 Charge pipe
28:10 Secondary O2 sensor and exhaust
35:47 Serpentine belt/tensioner
36:37 PCV and bypass valve lines
38:02 Final steps
38:42 Outro
#chevy #turbocharger #cruze #sonic #howto #turboswap #carmodification
ZZP is located in Wyoming, MI. We are the world’s largest supplier of aftermarket performance parts for 3800, Sonic/Cruze, Ecotec, and ATS platforms, providing industry-leading customer service and support.
Our staff of professionals has experienced knowledge in all the vehicle platforms we represent. ZZPerformance is dedicated to 100% customer satisfaction. We provide you with highly specific technical information, that can’t be found anywhere else.
Interested in modding your car? Check out our parts at zzperformance.com
Questions about modding? Email us at [e-mail]

[@noahlondot619]

I got this kit before y’all released the video and had to figure out how to install it this would’ve been a lot of help

[@scriptmike]

Wide-band 02 sensors needs to be before a cat! The coolant hose clamps in your kit are 18th century tech, move up to constant tension. clamps.

[@davidbaron6647]

😊 nice

[@rizeoutlaw2239]

You guys make any mods for 2009-2012 Chevy Malibu I’d love to see someone make mods for it

[@shaunbaker1979]

Check out super Cruzes they have Mods there for the Malibu too I believe

[@codygentry9472]

How about the rear tranz mount?

[@hagensperry119]

Not to hard of a process you have to pull your power steering motor out of it’s assembly to pull one bolt out other than that it’s easy as heck

[@mugiwara-reaper]

How much would this cost to put in ?

[@ZZPerformanceChannel]

If you're looking to have it installed by us, shoot us an email to [e-mail] and we can get you a quote and time frame.

[@miguelcunningham1812]

'Promosm'