BMW K1300S Adjusting balancing shafts English
Vložit
- čas přidán 26. 08. 2024
- BMW K1300S Adjusting balancing shafts
Precondition
balancing shaft (A),
Release clamping screws (1) and securing screws (2) of both balancing shafts
Install securing screws (2) and tighten until they are hand-tight.
Begin by adjusting balancing shaft (A), which is driven directly by the crankshaft:
Turn the eccentric of the directly driven balancing shaft clockwise until resistance is perceptible and a low grinding and whistling noise is audible.
Back off the eccentric by 1.5 index marks on the eccentric stub.
Tighten securing screw (2).
Adjust indirectly driven balancing shaft (B) last:
Turn the eccentric of the indirectly driven balancing shaft counter-clockwise until resistance is perceptible and a low grinding and whistling noise is audible.
Back off the eccentric by 1.5 index marks on the eccentric stub
Tighten securing screw
M8 x 30 20 Nm
M6 x 25 8 Nm