2013-2020 Suzuki 15HP Outboard Motor Impeller Replacement

2013-2020 Suzuki 15HP Outboard Motor Impeller Replacement
I hope you enjoy the video, that was my first time and I did it by looking at other videos and putting the pieces together. I went through some difficulties and was able to get it done. I have gone back and forward to make sure you do go through the same inconveniences. Thank you very much for washing let me know what you thing about it!

[@vdms4330]

Thank you very much for this video. I ordered the repair kit and I will replace the impeller on my engine with more confidence ;-)

[@Opie91]

Thanks for putting up the video. It answered all the questions I had.

[@LampLighter]

Excellent overview! Well done! I also have a Suzuki 15hp 4 stroke. Your demonstration was very helpful. God bless you and your family! 🤗

[@josevelasquez4400]

Where do get the parts

[@LampLighter]

@@josevelasquez4400 I ordered my parts from the Suzuki dealer! 👍😎

[@edelbertoescalera7990]

@@josevelasquez4400 I found a Suzuki dealer based in New York online and they shipped to Florida super fast. Can’t find the receipt now it was something Suzuki usa

[@henrythein8339]

A note: mark the shifting lever coupler on one of the faces with a marker and count the turns you did to unfasten it, retighten the same number of revolutions, this will put the length of the shift lever shaft back to where it was. Torque specs for the lower unit bolts is 17 ft lbs.

[@edelbertoescalera7990]

Shut, and how do I do now if I didn’t count it on the first place?

[@larrycote999]

VERY helpful. Thank you!

[@tonybraddock1514]

Thanks for the guidance😊

[@samirsofovic896]

Thanks, great and very helpful

[@iMadenid]

thanks bro 👍

[@markkus1134]

Just did mine motor is a 2001 low hour pump looked ok but bolts were a little tough on pump to get out cleaned them then a coat of grease so they will not get stuck too bad

[@bmsamson]

Thanks for this. I was having cooling water flow issues on my 2016 Suzuki 6hp o/b, just changed the impeller with no noticeable improvement. I feel steady pulse of air at the outflow hole, but that's it. No obstruction at the intake grate or the pipe from the water pump up to the head, so I suppose that means I have to crack the head (& cylinder?) and look for and clear obstruction somewhere in the casting? Any tips?

[@dominikols]

Is this hydrofoil increasing speed?

[@hakankalakar3719]

Adamsın bro

[@jeremykelton1663]

What do you do if it doesn't go back into gear?

[@nicholasnazelli4616]

terrible video, didn't understand a word you said!!!

[@edelbertoescalera7990]

What a hater 😂 then go and find a different video bro, if you couldn’t understand and this video didn’t help you out, you probably have worst problems than an impeller in your life, go and figure that out.