Velikost videa: 1280 X 720853 X 480640 X 360
Zobrazit ovladače přehrávání
Automatické přehrávání
Přehrát
Nice video sir, i hope u make a video for other generator, thanks and best regards
This dear friends
Yes
Another videos is an uploading, generators wiring video's
@@Info-Tech- thank you so much sir for sharing your knowledge in generator.
Thanks for the Info clarifications. Question, if I connect the ECM black power connector pins 1, 2, 23 & 42 to battery negative & pin 24 to battery positive should should pin 25 to the power relay become live with 24volts, Thank You.
Hi sir, this ecm wiring diagram same also for cummins and cat engine. Thanks
Nice video sir, can you share the pdf file of that wiring diagram?
The conclusion is that pin 25 is a negative ground "Feed" for the main power relay, so would test as power when checked on the genset...
Adjusting engine rpm speed.
The rpm is automatically adjusted by ecm, which is pre programmed, with ET software
Eng first thanks
Where I can get the wiring of Perkins2506A - E15TAG2
E-mail me abdurraheemk622@gmail. Com
Is there no other way to set the RPM from 1200 to 1500 RPM.?
No it's only possible to increase RPM with perkins ET software
Hello
Nice video sir, i hope u make a video for other generator, thanks and best regards
This dear friends
Yes
Another videos is an uploading, generators wiring video's
@@Info-Tech- thank you so much sir for sharing your knowledge in generator.
Thanks for the Info clarifications. Question, if I connect the ECM black power connector pins 1, 2, 23 & 42 to battery negative & pin 24 to battery positive should should pin 25 to the power relay become live with 24volts, Thank You.
Yes
Hi sir, this ecm wiring diagram same also for cummins and cat engine. Thanks
Nice video sir, can you share the pdf file of that wiring diagram?
The conclusion is that pin 25 is a negative ground "Feed" for the main power relay, so would test as power when checked on the genset...
Adjusting engine rpm speed.
The rpm is automatically adjusted by ecm, which is pre programmed, with ET software
Eng first thanks
Where I can get the wiring of Perkins
2506A - E15TAG2
E-mail me abdurraheemk622@gmail. Com
Is there no other way to set the RPM from 1200 to 1500 RPM.?
No it's only possible to increase RPM with perkins ET software
Hello