Impact Testing on ASME B31.3 Process Piping - API 570 and API SIFE Exam Question
Vložit
- čas přidán 14. 07. 2024
- Bob Rasooli explains impact test requirement as per ASME B31.3 for process piping which is API 570 piping inspector and API SIFE (source inspection fixed equipment) exams questions.The video indicates how exemption evaluation should be conducted. The video describes that piping material grouped in 4 curves and exemption depends on the assigned curve, wall thickness, minimum design metal temperature. If material minimum design temperature and wall thickness combination fall below the curve, then the impact test is a mandatory requirement. If it falls on the curve or above the curve, then is exempted.
Link to API 570 Piping Inspector Online Training: www.inspection-for-industry.c...
Link to API SIFE Source Inspector Fixed Equipment Online Training: www.inspection-for-industry.c... - Věda a technologie
your method of teaching is awesome
Superb lesson sir
Amazing videos thanks for doing these
Superb explanation boss.
Liked it
U made it very easy
Great work Bob
Awesome 👍 thank you very much sir
Good explain Sir. Thanks for your sharing
Very useful information 🙏🙏🙏🙏
Superb lecture sir
Great video
Thank You Sir
Thank you sir
Very much useful ❤️❤️❤️??sure channel would be remarked soon
Great
Thanks
nice
Excellent
Thanks
Excellent Mr.
Thank You
Sir If Table put on full screen we could easily to see and get clearly with your explanation
Thanks
How did you define "stress ratio"? i am doubt!
Sir please lacture of PWHT B31. 3
Could you please explain for MDMT -40 F and pipe material SA-516 Gr.B. Pipe 6" NPS and SCH. 40. Design temperature 95 C and pressure 5 psig...
Gr. B koi pipe nahi hota , lets assume A516 gr70 then it will fall under B-curve, temp95C hai toh thickness kuch bhi assume kroge impact test ki zaroorat nh hogi because curve upar ban rha hai
How A106 Gr.b belongs to curve D
Pwht B31. 3
Can someone PLEASE help me to find a solution to the below problem?
Thanks in advance.
An A 381 Y 35 pipe is 1.0” thick and is installed in a system operating at 150 psi. A replacement pipe will be ordered, and will be the same material (not normalized or quenched/tempered). If the design minimum temperature is 10F and the nominal pressure stress is 10,000 psi, what temperature can this material be operated at without impact testing?
min. of 20degree C, if stress ratio u will provide then maybe further can reduce
Thanks