These ATV Racks Were TERRIBLE!! Moto 4 Rack Restoration

The motor is taking a little longer than I hoped for so instead I moved to the wheeler racks! These racks had been welded on a lot in the past and it had just gobs of weld on it. So I ground down all the welds, added weld where there were holes, and then painted them. I think they turned out pretty sweet!
If you like what we're doing here at Toy Shop and would like to support us then be sure to check us out on Patreon! www.patreon.com/Toyshop9665?u...
Using these links will help me out!
Toolbox Widgets
1/4" drive Socket Widget - a.co/d/29Ux2rs
3/8" drive Socket Widget - a.co/d/5cCi3mT
1/2" drive Socket Widget - a.co/d/8EsPl9s
Screwdriver Widget - a.co/d/5F7EB5Y
Wrench Widget - a.co/d/0qyVzIM
Wide Motorcycle Scissor Jack - a.co/d/fQLQypt
Narrow Motorcycle Scissor Jack - a.co/d/cGDv73u
Umbilical tank setup;
Moton Pro Aux Tank - a.co/d/2hMd2xe
IV Stand - a.co/d/hHiSSGU
Metric #2 Phillips - a.co/d/1qhV0me
Slide Hammer - a.co/d/e8bu3yW
Camera I use to film - a.co/d/9d39Jjm
Mic I use - a.co/d/0V4vNZ7
Visit us at www.toyshop9665.com to see what we're up to and to check out everything Amsoil has to offer!

[@fardgodbssussybaka5280]

im excited to see the final result, im thinking of buying one just like this are they good enough quad?

[@ToyShop9665]

I’m excited too! And they’re a great little quad for what they are! They’re not fast but they’re dependable! Just get on them and cruise around.

[@brooketoy716]

Do you have recommendations on a cost effective welding helmet? I like yours......

[@ToyShop9665]

Ya harbor freight has good one 😉

[@joserribera4888]

Hey bud mine is stuck un reverse

[@ToyShop9665]

See your reverse lever? Follow that arm back to the cover it goes in. It’s probably broke or stuck under that cover. Only bummer is is I think to get that off you need to take the recoil and flywheel cover off to get the smaller cover off to see your issue. Hope you get it figured out!