Blue Devil Complete Coolant Flush and Oil Degreaser vs Rusty Coolant System, Does it Work?
Vložit
- čas přidán 8. 04. 2021
- in this video I decided to test blue devil coolant system flush on my Ford ranger with the worst coolant system I've ever seen, rusted out.
- Auta a dopravní prostředky
You should try citric acid, dissolve about a half a kilo in 10liters of warm/hot water, then fill up the system with it and use the car as usual. 24-48 hour later flush it well, and than fill up with coolant.
Thank you, I'll have to try it out. 👍
Won’t citric acid eat the rubber? I honestly don’t know, but I’ve used diluted citric acid to clean corrosion off of brass/copper, and it 1) eats the metal and 2) will eat heavy duty enamel paint off of a floor.
Citric acid is pretty awesome, but I’m not sure if I’d trust it in a car…. But I’m a novice. Just stating my thoughts hoping for insight.
I tried this in the system for 5 hours running errands etc and it did nothing, waste of time
If your coolant system contains more than 12 gallons and you only used one bottle, then your concentration level was too low to be optimally effective and you'll need to add an additional bottle of BlueDevil coolant system flush to get the desired result.
The problem isn't always the radiator itself. It's going to also be stuck in hoses, the water pump housing, water pump, thermostat and thermostat housing and ter heater pump.
I've been flushing my system put continuously and had stared off witu too bottled of some stuff I think called Mac as I was imma small torn at the time and they were very limited at that Nampa. Did one hole bottle liel instructions said for 30 mind but habe let it idle for an hour and half. Still. Dirty. I've been using sips at a girl from the second bottle and have been topping up witu distilled water and idle for hour and half each cycle. Did one run and drove 40 mins away and the the morning it was very full of rust when draining and it filled my entire radiant witu rust. My next flush I'm contemplating either Blue Devil or Thermocare....
Thermocure would take all that out. That stuff does wonders.
Thank you, I'll have to try it on that same engine.
What the hell? Why not try this at home??
EVERYDAY I RACE
What OBD II Using With Smartphone ???
I have a 3.2 F-150 look for a great upgrade Thank You.
Bafx products OBD2 diagnostic interface
Coolant would be good to add…one of coolants functions is anti rust.
This only says services up to 12 quarts. I have a 20 quart system. Should I put 2 in?
I’d have to say yes.
@@williamjones3480 and how many times did it take yours I used distilled good water to flush it all out when it was done. But how many times did it take you to make sure it was all flushed out after?? Plus I have a big V8 hemi
@@darthnevik5505 I’m actively sitting in my car with it running now. I guess I will have to answer you this afternoon sometime.
I think chrisfix used it and he flushed 3 times afterward. (But I could be completely mistaken. It’s been a while.)
I’m just going to do it until the water is clear after 30 minute run cycles, then letting it cool.
@@williamjones3480 make sure to bleed that cooling system once all the water
Comes out clear I used distilled water because ima perfectionist. But anyways I did it for about a hour. And ran water till it came out clear but once I put fresh antifreeze/coolant you need to bleed that thing. With it running. Just squeeze the upper house and get all those bubbles out
@@darthnevik5505 I bleed from the bleed screw above the heater hose. Is that wrong? It’s the highest point in the system.
It's not going to remove rust from the cap area it's doesn't right there open up the radiator first and see
Mine looks like that hope this shit works
Dang really I just bought some I was about to use it
I started mine around 6 o’crock also
💀
ok my system i did just the powr flsh it was perfect and clean when drained no rust in system or grease ...so today went to work door das drove at high sppeds it stayed cool after 1st p/u started car up bam full overheat ?????
so masde dlivery and sat for 1/2 hour put more antifreeze in wasable to keep working got home at 1 :15 am car li felt on idle it fucking overheated again!!! no leaks as far as i can teel so im goona use the prestone full system flush to clean everything heter core water pump etc... and drive all day tomorrow sat most likely full 11 - 12 hours and if it overheats after removing the water n flush in there and putting in full concetrate anti freeze ..... i'll just freaking screammmm
Try Thermacore or Evaporust.
Thermocure is quite expensive....
Does thermocure actually work to remove the rust without destroying the gaskets and components?
Rah roh
C'mon man get a new radiator 🤔🤔🤔
Sucks then huh...