Video

Have you ever used LED bulbs…my ‘59 you can not see in the daylight 🤦‍♂️

Thanks.

Great thanks

Thank you and would you please tell me (if the end of that lock cylinder pushes in)?

Bro is literally Peter Griffen

❤

grüße aus berlin es grüßt der berliner

What do I check if I’m only getting cold air in the back and hot in the front

Thank you ima make a boom box out of the old radio as for some reason gm cars have great reception

Great vedio and instruction. 👍👍 What's the model of the mirror? my original one is broken and I cannot read any info from the mirror. mine is same as yours thanks :)

Great job my friend

12 years later you posted this video and still helping noobs like me, thank you!

I did it. Thank you so much. Greetings from Russia.

You put more oil in the injector than you need, extra to purge the air. Put the hose over the original container, holding the injector and hose as vertically as you can, screw the injector to the 1/4 oz mark. Hook it to the low port and screw it all the way in.

❤

Radio fuse Replace bad fuses for radio 2005 cobalt

Thank you for telling me what my haynes manual didn't , I've looked all over and no body has given a clear answer until your video.

So clean!

Well done on the video. Thank you for your help!

You put the dirty one back in, too cheap to buy a new one for the video ?

Excellent tutorial!! I'm just taking them off my truck!! Thank you!!

Im looking for a permanent solution so i can use a car stereo at home using a PC power supply

Thanks!

Richpin is BACK!! Thanks for making clear and simple for me to show my brother-in-law! You're still the man I go to for instructional repair videos😉. Thanks Buddy!!!🚙🚗

Pain in the but some times

Rich long time no see body Sumer is here time for some more videos good job

Hope they actually replaced with new clean one. Also like the ones that remove allergy spores, mold, pollen.

What a real man indeed ! One handed i was amazed lol thank you mister ! Have a blessed day 🙏

Intake valve off a briggs and stratton.....lol

I don't believe you stated the year model of your Accord. It's not in the title anyway. Different model years will have a different method to remove the fuel pump and/or sending unit.

2002 Durango 5.9 crank no start. Coil signal wire is not 'fluttering'. Key on is solid at 12+ volts for a second or so, as it should, then off. When cranking LED test light attached to coil trigger wire is solid . . . . at 12 to 10 volts per trusty Harbor Freight voltmeter. Instruments show no problems. Coil itself tests good, even tried a second coil - same behavior. Checked each and every fuse. Went through what I think are all the obvious factors. Coil outlet terminal shows a sold 12v when cranking, but no sparking to ground when using spark plug tester. Any insights welcome.

Thank you for the video sir

They are not all aluminum. Maybe 20%

Would u know the year model fusion?🤔

What was the reason you changed the resistor in the first place? No low speed? When you did the resistor test. Were you testing the resistor your took out of the new one you put in?

service and check engine are two different things. you say the light in the middle. that's the service light. just needs an oil change.

Duct tape a smaller diameter tube to the end of a wet/dry vacuum hose. Feed into ac drain and suction out.

Mines ain’t getting ground. What does that mean?

Richpin, I have a 1998 Saturn SW1. I doe not have a secondary pump in the location shown on this video.(Right below the wiper fluid reservoir). I have searched the internet until my fingers hurt. I do not even see that part for my year and model of Saturn. Do you know if my year and model even had a secondary air pump?

Hola , como quito el cedazo ?

I love all your videos but I am astonished that you didn't include any footage of installing the new head gasket!!!

Thanks , great video. Just what I was looking for.

Is it (Immobilizer) ?

Thank you - no wonder I couldn't see it on an N16 Pulsar

Thanks

Will welcome me to the club. Mines blew up today. 😂

Can that cluster be opened up to check for poor connections of the led backlighting or for cold solder joints? Mine has an intermittent backlight flicker or on off on both the speedo and odometer. Same for my cruise control light.

Best how to video for this car I've seen yet

"This little piece right here" at 1:39 made all the difference! Thanks!

My 10mm nuts on the heat riser snapped off on one side. What do I do now???